LH28F800SG-L Datasheet, PDF (26/45 Pages) Sharp Electrionic Components – 8 M-bit (512 kB x 16) SmartVoltage Flash Memories

LH28F800SG-L/SGH-L (FOR TSOP, CSP)
6 ELECTRICAL SPECIFICATIONS
6.1 Absolute Maximum Ratings^∗
Operating Temperature
• LH28F800SG-L
During Read, Block Erase, Word Write,
and Lock-Bit Configuration ^........ 0 to +70°C ^{(NOTE 1)}
Temperature under Bias............ – 10 to +80°C
• LH28F800SGH-L
During Read, Block Erase, Word Write,
and Lock-Bit Configuration ^... –40 to +85°C ^{(NOTE 2)}
Temperature under Bias............. –40 to +85°C
Storage Temperature........................ –65 to +125°C
Voltage On Any Pin
(except VCC, VPP, and RP#) ^.... –2.0 to +7.0 V ^{(NOTE 3)}
VCC Supply Voltage................. –2.0 to +7.0 V ^{(NOTE 3)}
VPP Update Voltage during
Block Erase, Word Write, and
Lock-Bit Configuration ^.... –2.0 to +14.0 V ^{(NOTE 3, 4)}
RP# Voltage with Respect to
GND during Lock-Bit
Configuration Operations.. –2.0 to +14.0 V ^{(NOTE 3, 4)}
Output Short Circuit Current ^{..............} 100 mA ^{(NOTE 5)}
NOTICE : The specifications are subject to
change without notice. Verify with your local
SHARP sales office that you have the latest
datasheet before finalizing a design.
∗_{WARNING : Stressing the device beyond the}
"Absolute Maximum Ratings" may cause
permanent damage. These are stress ratings only.
Operation beyond the "Operating Conditions" is not
recommended and extended exposure beyond the
"Operating Conditions" may affect device reliability.
NOTES :
1. Operating temperature is for commercial product defined
by this specification.
2. Operating temperature is for extended temperature
product defined by this specification.
3. All specified voltages are with respect to GND. Minimum
DC voltage is –0.5 V on input/output pins and – 0.2 V on
VCC and VPP pins. During transitions, this level may
undershoot to –2.0 V for periods < 20 ns. Maximum DC
voltage on input/output pins and VCC is VCC+0.5 V
which, during transitions, may overshoot to VCC+2.0 V
for periods < 20 ns.
4. Maximum DC voltage on VPP and RP# may overshoot
to +14.0 V for periods < 20 ns.
5. Output shorted for no more than one second. No more
than one output shorted at a time.
6.2 Operating Conditions
SYMBOL
PARAMETER
TA
Operating Temperature
VCC1 VCC Supply Voltage (2.7 to 3.0 V)
VCC2 VCC Supply Voltage (3.3±0.3 V)
VCC3 VCC Supply Voltage (5.0±0.25 V)
VCC4 VCC Supply Voltage (5.0±0.5 V)
NOTE :
1. Test condition : Ambient temperature
NOTE
1
MIN.
0
– 40
2.7
3.0
4.75
4.50
MAX.
+70
+85
3.0
3.6
5.25
5.50
UNIT
˚C
˚C
V
V
V
V
VERSIONS
LH28F800SG-L
LH28F800SGH-L
LH28F800SG-L70/SGH-L70
- 26 -