LU6000F0 Datasheet, PDF (2/3 Pages) Sharp Electrionic Components – 16-Bit Single-Chip Microcomputers (With Built-In Flash Memory)

LU6000F0/LU6000F1
• Debug function :
FLASH MEMORY FEATURES
Program execusion breaks can be made on
• Writing method
arbitrary program memory address.
Using instruction : in the same way as used for
• Supply voltages :
SHARP 8 M bits flash mem-
4.5 to 5.5 V (main clock at 30 MHz)
ory LH28F008SA
2.7 to 3.6 V (main clock at 20 MHz, single chip
Auto byte write : through the command user
mode)
interface CUI
• Packages :
VPP : 12 V (external)
100-pin LQFP (LQFP100-P-1414)(LU6000F1)
100-pin QFP (QFP100-P-1420)(LU6000F0)
NOTES :
• Refer to the SM6000 series concerning about system/
functional information of LU6000F0/F1.
• Electrical characteristics are partly changed from SM6000
series.
• Erasing method
Auto block erase by CUI
• Block configuration
Y 8 blocks (1 block by 12 k bytes, 7 blocks by
16 k bytes)
Each block can be cleared independently.
R • Reliability
Write/erase cycles : 100
• 3 writing modes
A _{PROM mode}
Program can be stored/erased by using general
purpose PROM writer.
I ^{NSerial mode (on-board mode)}
Data can be read/written/erased from PC.
Copy mode
When the dedicated copy board is used, data
Mstored in PROM can be copied into the internal
flash memory.
I _{To write data into the internal flash memory,}
P ^{R E L special adapter and board are required.}
-2-