GP2W0002YP Datasheet, PDF (13/14 Pages) Sharp Electrionic Components – Low Power Infrared Transceiver

Low Power Infrared Transceiver
GP2W0001YP/GP2W0002YP
MOISTURE-PROOF PACKING
INFORMATION
Scope
This section describes the specifications of
GP2W0001YP/GP2W0002YP moisture-proof packing,
and is only for reference. The official specifications
should be consulted for packing information.
Packing Material Specifications
The GP2W0001YP/GP2W0002YP reel is moisture-
proof packed for shipment. Table 3 describes the mate-
rials used for each item of the moisture-proof packing.
Packing Method
1. Seal the aluminum laminate bag that contains the
tape reel (2,000 devices/reel) and desiccant.
2. Fill in the necessary information on the label and
paste it on the aluminum laminate bag.
3. Pack 4 aluminum laminated bags (1 reel each) into
the designated outer case, placing paper pads on
the bottom and top of the outer case, as well as be-
tween each layer of the aluminum laminated bags.
See Table 4.
4. Seal the outer case with craft tape, indicating the
model name, quantity, and out-going inspection date
on the case. (8,000 pieces total per carton)
Storage and Treatment
STORAGE CONDITIONS
The product should be stored under these conditions:
• Storage temperature: 10°C to 30°C
• Humidity: below 60% RH
TREATMENT AFTER UNSEALING
1. After unsealing, devices should be mounted at a
temperature of 10°C to 30°C, humidity below 60%
RH, within 3 days.
2. For long term storage, devices should either be
stored in a dry box, or re-sealed in a moisture-proof
bag with desiccant and stored in an environment
where the temperature is 10°C to 30°C, humidity be-
low 60% RH. Devices must be mounted within 2
weeks.
BAKING BEFORE MOUNTING
If the devices are not kept in the storage conditions
described above, or the desiccant indicator has turned
pink, baking must be performed before devices are
mounted: baking may only be done once.
• Recommended Baking Conditions: 100°C
12 to 24 hours
NOTE: Do not bake the devices while they are still on the reel — the
reel will melt. Parts should be either temporarily mounted to
a PCB with adhesive, or placed in a metal tray. Any device
that has been out of its dry pack for more than 72 hours
should be dried in some manner prior to any automated sur-
face mount reflow process. Otherwise these devices should
be mounted and soldered by hand.
Table 3. Packing Materials
ITEM
Aluminum Laminate Bag
Label
Desiccant
Outer Case
Pads
MATERIAL
Aluminum Polyethylene
Paper
Paper
Paper
Table 4. Packing Quantities
PACKING SHAPE
Tape reel (∅ 330 mm)
PRODUCT
1 model
QUANTITY PER REEL
2,000 pieces
NOTE: Minimum order/shipment quantity should be one laminated bag (1 reel of 2,000 pieces).
QUANTITY PER BAG
1 reel
Technical Information
13