GP1A34LC Datasheet, PDF (1/4 Pages) Sharp Electrionic Components – OPIC Photointerrupter with Connector

GP1A34LC
s Features
1. Snap-in mounting type
2. Can be mounted on 2 different thickness
boards
( 1.0mm, 1.6mm ) .
3. Uses 3-pin connector terminal
4. High sensing accuracy ( Slit width : 0.5mm )
5. Wide gap between light emitter and detec-
tor ( 5mm )
s Applications
1. Copiers, printers, facsimiles
GP1A34LC
OPIC Photointerrupter with Con-
nector
s Outline Dimensions
(Unit : mm )
(3.9)
21.8
16.0
0.9 6.5
4.5 5.0 4.5
Internal connection diagram
Voltage regulator
Amp.
1 1 VO
2 _{2 GND}
3 ^{3 VCC}
6.0
3.0
0.5 ^{± 0.1}
Slit width
g
32
1
0.9
2 - 4.0
4.0
2 - 8.0
2 - 0.9 2 - 0.9
2 - 11.8
2 - 3.0
10.2
* Unspecified tolerances shall be as follows ;
Dimensions(d) Tolerance
d< 5.0 ± 0.15
5.0<=d< 15.0 ± 0.2
15.0<=d
± 0.3
* ( ): Reference dimensions
g JAPAN AMP made connector
Ultrex 172681-3
Recommended connector on the inserted side
172685-3, etc. ^gg
*“OPIC” ( Optical IC ) is a trademark of the SHARP Corporation.
An OPIC consists of a light-detecting element and signal-
processing circuit integrated onto a single chip.
gg Recommended connectors on the inserted side
are shown on the page after next.
s Absolute Maximum Ratings
(Ta = 25˚C )
Parameter
Supply voltage
*1_{Output voltage}
*2 _{Low level output current}
*3 _{Operating temperature}
*3 _{Storage temperature}
Symbol Rating Unit
VCC - 0.5 to + 7 V
VO - 0.5 to + 13 V
I OL
10
mA
Topr - 20 to + 75 ˚C
Tstg - 30 to + 85 ˚C
*1 Collector-emitter voltage of output transistor
*2 Collector current of output transistor
*3 The connector should be plugged in/out and the unit's hook should
be used at normal temperature.
“ In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that occur in equipment using any of SHARP's devices, shown in catalogs,
data books, etc. Contact SHARP in order to obtain the latest version of the device specification sheets before using any SHARP's device.”