GP1A05A2 Datasheet, PDF (1/5 Pages) Sharp Electrionic Components – OPIC Photointerrupter with Connector

GP1A05A2
GP1A05A2
OPIC Photointerrupter with
Connector
s Features
1. Uses 3-pin connector terminal
2. High sensing accuracy (Slit width : 0.5mm)
3. Wide gap between light emitter and detector (5mm)
s Applications
1. Copiers, Printers
2. Facsimiles
s Absolute Maximum Ratings
(Ta=25˚C)
Parameter
Symbol Rating Unit
Suppl voltagey
VCC −0.5 to +8 V
*1 _{Output voltage}
VOUT −0.5 to +28 V
*2 _{Low level output current}
IOL
50
mA
*3 _{Operating temperature}
Topr −20 to +75 ˚C
*3 _{Storage temperature}
Tstg −40 to +85 ˚C
*1 Collector-emitter voltage of output transistor.
*2 Collector current of output transistor.
*3 The connector should be plugged in/out at normal temperature.
s Outline Dimensions
(Unit : mm)
φ3±0.1 Depth2.0
2
φ^4.2±0.2
15
55
1
2
3
7
3.5
Slit width0.5±0.1
Protrusion of connector
from holder : Max.1.0
C0.5 ^{Connector made}
by J.S.T. MFG. CO., LTD.
B3P-SHF-1AA
34.0
9.2±1
BD
YZ1
11±0.1 12±0.1
g Unspecified tolerances shall be as follows
Dimensions (d)
d<4.0
4.0<=d<16.0
16.0<=d
Tolerance
±0.2
±0.3
±0.5
1
Voltage regulator
Amp.
2
1 V_CC
3
2 GND
3 V_O
* "OPIC" (Optical IC) is a trademark of the SHARP Corporation.
An OPIC consists of a light-detecting element and signal-processing circuit
integrated onto a single chip.
Notice In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
Internet Internet address for Electronic Components Group http://www.sharp.co.jp/ecg/