SGM44600_15 Datasheet, PDF (2/11 Pages) SG Micro Corp – DPDT Analog Switch

SGM44600
4Ω, High Speed, Low Voltage
Dual, DPDT Analog Switch
PACKAGE/ORDERING INFORMATION
MODEL
SGM44600
PIN-
PACKAGE
TQFN-3×3-16L
SPECIFIED
TEMPERATURE
RANGE
-40℃ to +85℃
ORDERING
NUMBER
SGM44600YTQ16/TR
PACKAGE
MARKING
44600
PACKAGE
OPTION
Tape and Reel, 3000
ABSOLUTE MAXIMUM RATINGS
V+ to GND.......................................................................0V to 6V
Analog, Digital voltage range…....................-0.3V to (V₊) + 0.3V
Continuous Current NO, NC, or COM ...........................±100mA
Operating Temperature Range............................-40℃ to +85℃
Junction Temperature.......................................................150℃
Storage Temperature Range................................-65℃ to +150℃
Lead Temperature (soldering, 10s)......................................260℃
ESD Susceptibility
HBM................................................................................... 2000V
MM........................................................................................200V
NOTE: Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are
stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational
sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device
reliability.
CAUTION
This integrated circuit can be damaged by ESD if you don’t pay attention to ESD protection. SGMICRO recommends that all
integrated circuits be handled with appropriate precautions. Failure to observe proper handling and installation procedures can cause
damage. ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may
be more susceptible to damage because very small parametric changes could cause the device not to meet its published
specifications.
SGMICRO reserves the right to make any change in circuit design, specification or other related things if necessary without notice at
any time. Please contact SGMICRO sales office to get the latest datasheet.
PIN DESCRIPTION
NAME
V₊
GND
IN
N.C.
COM_X
NO_X
NC_X
Exposed
Pad
PIN
14
6
2
10
16, 4, 8, 12
15, 3, 7, 11
1, 5, 9, 13
FUNCTION
Power Supply.
Ground.
Digital Control Pin to Connect the COM Terminal to the NO or NC Terminals.
Not Internally Connected.
Common Terminal.
Normally-Open Terminal.
Normally-Closed Terminal.
GND
Exposed pad should be soldered to PCB board and connected to GND.
NOTE: NOX, NCX and COMX terminals may be an input or output.
SG Micro Corp
2
www.sg-micro.com