SC622A_09 Datasheet, PDF (19/23 Pages) Semtech Corporation – LED Light Management Unit Charge Pump, 400mA Flash LED,Dual LDOs,and I2C Interface

SC622A
Register and Bit Definitions (continued)
FL/SPLB
This bit is used to select either the flash or spotlight
current ranges. If this bit is set, the FL current sink can
be used to drive a flash of maximum duration 500ms and
the current range will be the high (flash) current range. If
this bit is cleared, the FL current sink can be used to drive
a continuous spotlight at a lower current and the current
range will be the lower (spotlight) current range, as shown
in Table 1.
LDO Control Register (0x03)
This register is used to enable the LDOs and to set their
output voltages.
LDO2[2:0]
These bits are used to set the output voltage of LDO2, as
shown in Table 2.
Table 2 — LDO2 Control Bits
LDO2_2
LDO2_1
LDO2_0
LDO2
Output Voltage
0
0
0
OFF
0
0
1
1.8V
0
1
0
1.7V
0
1
1
1.6V
1
0
0
1.5V
101 through 111 are not used
OFF
LDO1[3:0]
These bits set the output voltage of LDO1, as shown in
Table 3.
Table 3 — LDO1 Control Bits
LDO1_3 LDO1_2 LDO1_1 LDO1_0
LDO1
Output
Voltage
0
0
0
0
OFF
0
0
0
1
3.3V
0
0
1
0
3.2V
0
0
1
1
3.1V
0
1
0
0
3.0V
0
1
0
1
2.9V
0
1
1
0
2.8V
0
1
1
1
2.7V
1
0
0
0
2.6V
1
0
0
1
2.5V
1010 through 1111 are not used
OFF
19