English
Language : 

SKHI61 Datasheet, PDF (7/8 Pages) Semikron International – Sixpack IGBT and MOSFET Driver
Fig. 8 Examply circuit for a SKHI 71 connected to the primary side
NOTE: If the _ErrorOut-signal of the additional switch (here brake chopper) is also needed for other evaluations, a
Schottky diode has to be connected as shown in the figure above to uncouple the signal. Furthermore there has to be
connected a pull-up resistor to the additional error output. It is useful to use a capacitor (typ. 100 pF, absolute maximum
2,2 nF) at the _ErrorIn to avoid undesired couplings.
Fig. 9 Dimensional drawing, layout
View: tooling side (top view, driver put on top of the PCB)
Measurements taken in [mm]
Grid of connector pins; gaps between pins: RM2,54
Pin dimensions : 0,64 mm x 0,64 mm ; length 3,2 mm
1928 Driver Electronic – PCB Drivers
23-02-2004 © by SEMIKRON