LC87F7932B Datasheet, PDF (5/29 Pages) Sanyo Semicon Device – 32K-byte FROM and 2048-byte RAM integrated 8-bit 1-chip Microcontroller

LC87F7932B
„Standby Function
• HALT mode
HALT mode is used to reduce power consumption. During the HALT mode, program execution is stopped but
peripheral circuits keep operating (Some parts of serial transfer operation stop.)
(1) Oscillation circuits are not stopped automatically.
(2) Released by the system reset or interrupts.
• HOLD mode
HOLD mode is used to reduce power consumption. Program execution and peripheral circuits are stopped.
(1) CF, RC and crystal oscillation circuits stop automatically.
(2) Released by any of the following conditions.
1) Low level input to the reset pin
2) Watchdog timer interrupt
3) Specified level input to one of INT0, INT1, INT2
4) Port 0 interrupt
5) SPI interrupt by receiving 1-byte (8-bit clock)
• X’tal HOLD mode
X’tal HOLD mode is used to reduce power consumption. Program execution is stopped.
All peripheral circuits except the base timer are stopped.
(1) CF and RC oscillation circuits stop automatically.
(2) Crystal oscillator operation is kept in its state at HOLD mode inception.
(3) Released by any of the following conditions.
1) Low level input to the reset pin
2) Watchdog timer interrupt
3) Specified level input to one of INT0, INT1, INT2
4) Port 0 interrupt
5) Base-timer interrupt
6) RTC interrupt
7) SPI interrupt by receiving 1-byte (8-bit clock)
„Onchip debugger
• Supports software debugging with the IC mounted on the target board.
„Shipping Form
• QIP64E (14×14) (Lead-/Halogen-free type)
• TQFP64J (7×7) (Lead-/Halogen-free type)
• SQFP64 (10×10) (Lead-/Halogen-free type)
„Development Tools
• On-chip debugger: TCB87 TypeB+LC87F7932B
„Flash ROM Programming Boards
Package
Programming boards
QIP64E (14×14)
W87F70256Q
TQFP64J (7×7)
W87F70256TQ7
SQFP64 (10×10)
W87F79256SQ
No.A1841-5/29