English
Language : 

LC86E6449 Datasheet, PDF (5/22 Pages) Sanyo Semicon Device – 8-Bit Single Chip Microcontroller with the UVEPROM
LC86E6449
How to use
(1) Specification of option
Programming data for EPROM of the LC86E6449 is required.
Debugged evaluation file (EVA file) must be converted to an INTEL-HEX formatted file (HEX file) with file converter
program, EVA2HEX.EXE. The HEX file is used as the programming data for the LC86E6449.
(2) How to program for the EPROM
LC86E6449 can be programmed by the EPROM programmer with attachment ; W86EP6448Q.
• Recommended EPROM programmer
Productor
Advantest
Andou
AVAL
Minato electronics
EEPROM programmer
R4945, R4944, R4943
AF-9704
PKW-1100, PKW-3000
MODEL 1890A
• “27512 (Vpp=12.5V) Intel high speed programming” mode available. The address must be set to “0 to
0FFFFH” and a jumper (DASEC) must be set to ‘OFF’ at programming.
(3) How to use the data security function
“Data security” is the disabled function to read the data of the EPROM.
The following is the process in order to execute the data security.
1. Set ‘ON’ the jumper of attachment.
2. Program again. Then EPROM programmer displays the error. The error means normally activity of the data security.
It is not a trouble of the EPROM programmer or the LSI.
Notes
• Data security is not executed when the data of all address have ‘FFH’ at the sequence 2 above.
• The programming by a sequential operation “BLANK⇒PROGRAM⇒VERIFY” cannot be executed data security at the
sequence 2 above.
• Set to ‘OFF’ the jumper after executing the data security.
Data security
1 pin mark
of LSI
1 pin
Not data security
W86EP6448Q
No.6746-5/22