LC87F1L16A Datasheet, PDF (4/24 Pages) Sanyo Semicon Device – 8-bit 1-chip Microcontroller with USB-host controller

LC87F1L16A
„Standby Function
• HALT mode: Halts instruction execution while allowing the peripheral circuits to continue operation.
1) Oscillation is not halted automatically.
2) There are three ways of resetting the HOLD mode.
(1) Setting the reset pin to the lower level
(2) System resetting by watchdog timer
(3) Occurrence of an interrupt
• HOLD mode: Suspends instruction execution and the operation of the peripheral circuits.
1) The PLL base clock generator, CF, RC and crystal oscillators automatically stop operation.
2) There are five ways of resetting the HOLD mode.
(1) Setting the reset pin to the lower level
(2) System resetting by watchdog timer
(3) Having an interrupt source established at either INT0, INT1, INT2, INT4 or INT5
* INT0 and INT1 HOLD mode reset is available only when level detection is set.
(4) Having an interrupt source established at port 0
(5) Having an bus active interrupt source established in the USB host controll circuit
• X'tal HOLD mode: Suspends instruction execution and the operation of the peripheral circuits except the base timer.
1) The PLL base clock generator, CF and RC oscillator automatically stop operation.
2) The state of crystal oscillation established when the X'tal HOLD mode is entered is retained.
3) There are six ways of resetting the X'tal HOLD mode.
(1) Setting the reset pin to the low level
(2) System resetting by watchdog timer
(3) Having an interrupt source established at either INT0, INT1, INT2, INT4 or INT5
* INT0 and INT1 HOLD mode reset is available only when level detection is set.
(4) Having an interrupt source established at port 0
(5) Having an interrupt source established in the base timer circuit
(6) Having an bus active interrupt source established in the USB host controll circuit
„Package Form
• SQFP48 (7×7): Lead-/Halogen-free type
„Development Tools
• On-chip debugger: TCB87 type-B + LC87F1L16A or TCB87 type-C (three wire cable) + LC87F1L16A
„Flash ROM Programming Boards
Package
Programming Boards
SQFP48(7 × 7)
W87F55256SQ
„Flash Programmer
Maker
Flash Support Group, Inc.
(FSG)
Single
Programmer
Flash Support Group, Inc.
(FSG)
+
Sanyo (Note 1)
Onboard
Single/Gang
Programmer
Single/Gang
Programmer
Sanyo
Onboard
Single/Gang
Programmer
For information about AF-Series:
Flash Support Group, Inc.
TEL: [phone]
E-mail: [e-mail]
Model
AF9709/AF9709B/AF9709C
(Including Ando Electric Co., Ltd. models)
AF9101/AF9103 (Main unit)
(FSG models)
SIB87(Inter Face Driver)
(Sanyo model)
SKK/SKK TypeB
(SanyoFWS)
SKK-DBG TypeB
(SanyoFWS)
Supported version
Rev 03.18c or later
(Note 2)
Application Version
1.04 or later
Chip Data Version
2.21 or later
Device
LC87F1L16A
LC87F1L16A
LC87F1L16
Note1: On-board-programmer from FSG (AF9101/AF9103) and serial interface driver from SANYO (SIB87)
together can give a PC-less, standalone on-board-programming capabilities.
Note2: It needs a special programming devices and applications depending on the use of programming environment.
Please ask FSG or SANYO for the information.
No.A1835-4/24