LC87F1L16A Datasheet, PDF (15/24 Pages) Sanyo Semicon Device – 8-bit 1-chip Microcontroller with USB-host controller

LC87F1L16A
Serial I/O Characteristics at Ta = -40°C to +85°C, VSS1 = VSS2 = VSS3 = 0V
1. SIO0 Serial I/O Characteristics (Note 4-1-1)
Parameter
Frequency
Symbol
tSCK(1)
Pin/
Remarks
SCK0(P12)
Conditions
See Fig. 8.
Specification
VDD[V]
min
typ
max
unit
2
Low level
pulse width
High level
pulse width
Frequency
Low level
pulse width
High level
pulse width
Data setup time
Data hold time
tSCKL(1)
1
tSCKH(1)
1
tSCKHA(1a)
tSCKHA(1b)
tSCK(2)
tSCKL(2)
SCK0(P12)
• Continuous data transmission/
reception mode
• USB not used at the same time.
• See Fig. 8.
• (Note 4-1-2)
• Continuous data transmission/
reception mode
• USB used at the same time.
• See Fig. 8.
• (Note 4-1-2)
• When CMOS output type is
selected
• See Fig. 8.
2.7 to 5.5
tSCKH(2)
4
7
4/3
1/2
1/2
tCYC
tSCK
tSCKHA(2a)
tSCKHA(2b)
tsDI(1)
thDI(1)
SB0(P11),
SI0(P11)
• Continuous data transmission/
reception mode
• USB not used at the same time.
• When CMOS output type is
selected
• See Fig. 8.
• Continuous data transmission/
reception mode
• USB used at the same time.
• When CMOS output type is
selected.
• See Fig. 8.
• Must be specified with respect
to rising edge of SIOCLK.
• See Fig. 8.
2.7 to 5.5
tSCKH(2)
+2tCYC
tSCKH(2)
+2tCYC
0.03
2.7 to 5.5
0.03
tSCKH(2)
+(10/3)
tCYC
tCYC
tSCKH(2)
+(19/3)
tCYC
Output delay
time
tdD0(1)
tdD0(2)
tdD0(3)
SO0(P10),
SB0(P11)
• Continuous data transmission/
reception mode
• (Note 4-1-3)
• Synchronous 8-bit mode
• (Note 4-1-3)
(Note 4-1-3)
2.7 to 5.5
(1/3)tCYC
+0.05
μs
1tCYC
+0.05
(1/3)tCYC
+0.05
Note 4-1-1: These specifications are theoretical values. Margins must be allowed according to the actual operating
conditions.
Note 4-1-2: In an application where the serial clock input is to be used in the continuous data transfer mode, the time
from SI0RUN being set when serial clock is high to the falling edge of the first serial clock must be longer
than tSCKHA.
Note 4-1-3: Must be specified with respect to falling edge of SIOCLK.
Must be specified as the time to the beginning of output state change in open drain output mode. See Fig. 8.
No.A1835-15/24