LC863528 Datasheet, PDF (4/17 Pages) Sanyo Semicon Device – 8-bit 1-chip Microcontroller

LC863548B/40B/32B/28B/24B/20B/16B
■Sub-routine stack level
• A maximum of 128 levels (stack is built in the internal RAM)
■Multiplication/division instruction
• 16-bits × 8-bits (7 instruction cycle times)
• 16-bits ÷ 8-bits (7 instruction cycle times)
■3 oscillation circuits
• Built-in RC oscillation circuit used for the system clock
• Built-in VCO circuit used for the system clock and OSD
• X’tal oscillation circuit used for base timer, system clock and PLL reference
■Standby function
• HALT mode
The HALT mode is used to reduce the power dissipation. In this operation mode, the program execution is stopped.
This mode can be released by the interrupt request or the system reset.
• HOLD mode
The HOLD mode is used to stop the oscillations ; RC (internal), VCO, and X’tal oscillations.
This mode can be released by the following conditions.
1. Pull the reset terminal (RES) to low level.
2. Feed the selected level to either P70/INT0 or P71/INT1.
■Package
• MFP36S
• DIP36S
■Development tools
• Flash EEPROM
• Evaluation chip
• Emulator
: LC86F3548A
: LC863096
: EVA86000 (main) + ECB863200A (evaluation chip board)
+ SUB863400A (sub board)
+ POD36-CABLE (cable)
+ POD36-DIP (for DIP36S)
or POD36-MFP (for MFP36S)
No.7936-4/17