LC78620E Datasheet, PDF (30/34 Pages) Sanyo Semicon Device – Compact Disc Player DSP

LC78620E
• C1 and C2 Error Correction
The LC78620E writes EFM demodulated data to internal RAM to compensate for jitter and then performs the
following processing with uniform timing based on the crystal oscillator clock. First, the LC78620E performs C1
error checking and correction in the C1 block, determines the C1 flags, and writes the C1 flag register. Next, the
LC78620E performs C2 error checking and correction in the C2 block, determines the C2 flags, and writes data to
internal RAM.
C1 flag
No errors
1 error
2 errors
3 errors or more
Error correction and flag processing
No correction required · Flag reset
Correction · Flag reset
Correction · Flag set
Correction not possible · Flag set
C2 flag
No errors
1 error
2 errors
3 errors or more
Error correction and flag processing
No correction required · Flag reset
Correction · Flag reset
Depends on C1 flags^*1
Depends on C1 flags^*2
Note: 1. If the positions of the errors determined by the C2 check agree with those specified by the C1 flags, the correction is performed and the flags
are cleared. However, if the number of C1 flags is 7 or higher, C2 correction may fail. In this case correction is not performed and the C1 flags
are taken as the C2 flags without change. Error correction is not possible if one error position agrees and the other does not. Furthermore, if
the number of C1 flags is 5 or under, the C1 check result can be seen as unreliable. Accordingly, the flags will be set in this case. Cases
where the number of C1 flags is 6 or more are handled in the same way, and the C1 flags are taken as the C2 flags without change. When
there is not even one agreement between the error positions, error correction is, of course, impossible. Here, if the number of C1 flags was 2
or under, data that was seen as correct after C1 correction is now seen as incorrect data. The flags are set in this case. In other cases, the C1
flags are taken as the C2 flags without change.
2. When data is determined to have three or more errors and be uncorrectable, correction is, of course, impossible. Here, if the number of C1
flags was 2 or under, data that was seen as correct after C1 correction is now seen as incorrect data. The flags are set in this case. In other
cases the C1 flags are taken as the C2 flags without change.
No. 5130-30/34