LV8406T_12 Datasheet, PDF (2/6 Pages) Sanyo Semicon Device – 2ch Forward/Reverse Motor Driver

LV8406T
Allowable Operating Conditions at Ta = 25°C, SGND = PGND = 0V
Parameter
Power supply voltage (VM pin)
Power supply voltage (VCC pin)
Input signal voltage
Input signal frequency
Symbol
VM
VCC
VIN
f max
Conditions
Ratings
Unit
1.5 to 15.0 V
2.8 to 5.5 V
0 to VCC V
200 kHz
Electrical Characteristics Ta = 25°C, VCC = 3.0V, VM = VS = 6.0V, SGND = PGND = 0V, unless otherwise specified.
Parameter
Symbol
Conditions
Remarks
min
Ratings
Unit
typ
max
Standby load current drain
IMO
EN = 0V
1
1.0 μA
Standby control current drain
ICO
EN = IN1 = IN2 = IN3 = IN4 = 0V
2
1.0 μA
Standby load current drain2
IMO2
VCC = 0V, VM = VS = 6V
Operating control current drain
IC1
EN = 3V, with no load
3
1.0 μA
0.85
1.2 mA
High-level input voltage
Low-level input voltage
High-level input current
(EN1, EN2, IN1, IN2, IN3, IN4)
Low-level input current
(EN1, EN2, IN1, IN2, IN3, IN4)
Pull-down resistance value
VIH
VIL
IIH1
IIL1
RDN
2.7 ≤ VCC ≤ 5.5V
2.7 ≤ VCC ≤ 5.5V
VIN = 3V
VIN = 0V
EN1, EN2, IN1, IN2, IN3, IN4
0.6×VCC
0
4
4
-1.0
100
VCC V
0.2×VCC V
15
25 μA
μA
200
400 kΩ
Charge pump voltage
Output ON resistance 1
VG
RON1
VCC + VS
Sum of top and bottom sides ON
resistance.
8.5
9.0
9.5 V
5
0.75
1.2 Ω
Output ON resistance 2
RON2
Low-voltage detection voltage
Thermal shutdown temperature
VCS
Tth
Sum of top and bottom sides ON
resistance. VCC = 2.8V
VCC pin voltage is monitored
Design guarantee value *
5
1.0
1.5 Ω
6
2.15
2.30
2.45 V
7
150
180
210 °C
Output block Turn-on time TPLH
8
0.2
0.4 μS
Turn-off time TPHL
8
0.2
0.4 μS
* : Design guarantee value and no measurement is preformed.
Remarks
1. Current consumption when output at the VM pin is off.
2. Current consumption when the VCC pin when in standby mode.
3. Current consumption at the VCC pin when EN is 3V (standby mode).
4. Pins EN1, 2, IN1, 2, 3, and 4 are all pulled down.
5. Sum of upper and lower saturation voltages of OUT pin divided by the current.
6. All power transistors are turned off if a low VCC condition is detected.
7. All output transistors are turned off if the thermal protection circuit is activated. They are turned on again as the
temperature goes down.
8. Rising time from 10 to 90% and falling time from 90 to 10% are specified.
No.A1382-2/6