LC863432A Datasheet, PDF (14/19 Pages) Sanyo Semicon Device – 8-Bit Single-Chip Microcontroller

LC863432A/28A/24A/20A/16A
8. Sample Current Dissipation Characteristics at Ta=-10°C to +70°C, VSS=0V
The sample current dissipation characteristics is the measurement result of Sanyo provided evaluation board when the
recommended circuit parameters shown in the sample oscillation circuit characteristics are used externally. The currents
through the output transistors and the pull-up MOS transistors are ignored.
Parameter
Symbol
Current dissipation
during basic
operation
(Note 3)
IDDOP(1)
Pins
VDD
IDDOP(2) VDD
IDDOP(3) VDD
Current dissipation IDDHALT(1) VDD
in HALT mode
(Note 3)
IDDHALT(2) VDD
IDDHALT(3) VDD
Current dissipation IDDHOLD
in HOLD mode
(Note 3)
VDD
Conditions
VDD[V]
Ratings
min. typ. max.
unit
•FmX’tal=32.768kHz 4.5 to 5.5
17
28 mA
X’tal oscillation
•System clock :
VCO
•VCO for OSD
operating
•OSD is Digital mode
•Internal RC
oscillation stops
•FmX’tal=32.768kHz 4.5 to 5.5
26
40
X’tal oscillation
•System clock :
VCO
•VCO for OSD
operating
•OSD is Analog mode
•Internal RC
oscillation stops
•FmX’tal=32.768kHz 4.5 to 5.5
120 300 µA
X’tal oscillation
•System clock :
X’tal
•VCO for system
VCO for OSD,
internal RC
oscillation stop
•Data slicer, AD
converters stop
•HALT mode
4.5 to 5.5
5
10 mA
•FmX’tal=32.768kHz
X’tal oscillation
•System clock :
VCO
•VCO for OSD stops
•Internal RC
oscillation stops
•HALT mode
4.5 to 5.5
350 1000 µA
•FmX’tal=32.768kHz
X’tal oscillation
•VCO for system
stops
•VCO for OSD stops
•System clock :
Internal RC
•HALT mode
4.5 to 5.5
40
200
•FmX’tal=32.768kHz
X’tal oscillation
•VCO for system
stops
•VCO for OSD stops
•System clock : X’tal
•HOLD mode
4.5 to 5.5
0.05 20 µA
•All oscillation stops.
(Note 3) The currents through the output transistors and the pull-up MOS transistors are ignored.
No.6846-14/19