LC78622NE Datasheet, PDF (14/31 Pages) Sanyo Semicon Device – Compact Disc Player DSP

• TJ commands
MSB
LSB
10100000
10100001
00010001
00010010
00110001
01010010
00010000
00010011
00010100
00110000
00010101
00010111
00011001
00011010
00111001
01011010
00011000
00011011
00011100
00111000
00011101
00011111
00010110
00001111
10001111
10001100
00100001
00100000
LC78622NE
Command
STANDARD TRACK JUMP
NEW TRACK JUMP
1 TRACK JUMP IN #1
1 TRACK JUMP IN #2
1 TRACK JUMP IN #3
1 TRACK JUMP IN #4
2 TRACK JUMP IN
4 TRACK JUMP IN
16 TRACK JUMP IN
32 TRACK JUMP IN
64 TRACK JUMP IN
128 TRACK JUMP IN
1 TRACK JUMP OUT #1
1 TRACK JUMP OUT #2
1 TRACK JUMP OUT #3
1 TRACK JUMP OUT #4
2 TRACK JUMP OUT
4 TRACK JUMP OUT
16 TRACK JUMP OUT
32 TRACK JUMP OUT
64 TRACK JUMP OUT
128 TRACK JUMP OUT
256 TRACK CHECK
TOFF
TON
TRACK JUMP BRAKE
TOFF OUTPUT MODE DURING JP PULSE PERIOD
RESET TOFF OUTPUT MODE DURING JP PULSE PERIOD
RES = low
q
q
q
When the LC78622NE receives a track jump instruction as a servo command, it first generates accelerating pulses
(period a) and next generates deceleration pulses (period b). The passage of the braking period (period c) completes
the specified jump. During the braking period, the LC78622NE detects the beam slip direction from the TES and
HFL inputs. TOFF is used to cut the components in the TES signal that aggravate slip. The jump destination track
is captured by increasing the servo gain with TGL. In during TOFF output mode JP pulse period the TOFF signal
is held high during the JP pulse generation period.
Note: Of the modes related to disk motor control, the TOFF pin only goes low in CLV mode, and will be high
during accelerate, stop, and decelerate modes.Note that the TOFF pin can be turned on and off
independently by microprocessor issued commands. However, this function is only valid when disk motor
control is in CLV mode.
No. 6015-14/31