|
BD9152MUV Datasheet, PDF (9/18 Pages) Rohm – Output 1.5A or Less High Efficiency Step-down Switching Regulator with Built-in Power MOSFET | |||
|
◁ |
BD9152MUV
Technical Note
ã»Short-current protection circuit with time delay function
Turns OFF the output to protect the IC from breakdown when the incorporated current limiter is activated continuously for
the fixed time(TLATCH) or more. The output thus held tuned OFF may be recovered by restarting EN or by re-unlocking
UVLO.
EN1ï¼EN2
Output Short circuit
Threshold Voltage
VOUT2
IL1
IL Limit
Output OFF
Latch
Standby
mode
EN
t1<TLATCH
Operating mode
t2=TLATCH
Standby
mode
Operating mode
Timer latch
EN
Fig.31 Short-current protection circuit with time delay timing chart
âSwitching regulator efficiency
Efficiency Å may be expressed by the equation shown below:
η= VOUTÃIOUT Ã100[%]= POUT Ã100[%]=
POUT
Ã100[%]
VinÃIin
Pin
POUT+PDα
Efficiency may be improved by reducing the switching regulator power dissipation factors PDα as follows:
Dissipation factors:
1) ON resistance dissipation of inductor and FETï¼PD(I2R)
2) Gate charge/discharge dissipationï¼PD(Gate)
3) Switching dissipationï¼PD(SW)
4) ESR dissipation of capacitorï¼PD(ESR)
5) Operating current dissipation of ICï¼PD(IC)
1)PD(I2R)=IOUT2Ã(RCOIL+RON) (RCOIL[Ω]ï¼DC resistance of inductor, RON[Ω]ï¼ON resistance of FET, IOUT[A]ï¼Output
current.)
2)PD(Gate)=CgsÃfÃV (Cgs[F]ï¼Gate capacitance of FET, f[H]ï¼Switching frequency, V[V]ï¼Gate driving voltage of FET)
3)PD(SW)=
Vin2ÃCRSSÃIOUTÃf
IDRIVE
(CRSS[F]ï¼Reverse transfer capacitance of FET, IDRIVE[A]ï¼Peak current of gate.)
4)PD(ESR)=IRMS2ÃESR (IRMS[A]ï¼Ripple current of capacitor, ESR[Ω]ï¼Equivalent series resistance.)
5)PD(IC)=VinÃICC (ICC[A]ï¼Circuit current.)
www.rohm.com
âc 2009 ROHM Co., Ltd. All rights reserved.
9/17
2009.05 - Rev.A
|
▷ |