BU24026GU_11 Datasheet, PDF (7/8 Pages) Rohm – Silicon monolithic integrated circuit

◇Pin assignment diagram (reverse side)
G
VDDAMP
OUT６B
MGND５６
OUT６A
MVCC５６
OUT５A
OUT５B
F
SENSE
VDDAMP
SO１
STATE２
STATE３
OUT５B
OUT４B
E
OUT７A
DVSS
PIOUT１
STATE１
SI１
DVDD
OUT４A
D
RNF
PIOUT2
SDATA
CSB
IN５６
SO３
MGND３４
C
OUT7B
FCLK
SO２
IN７
SI３
OUT３B
B
MGND７
MVCC12
SCLK
SI２
SOUT
MVCC３４
OUT３A
A
MVCC12
OUT1A
OUT1B
MGND１２
OUT2A
OUT２B
MVCC３４
1
2
3
4
5
6
7
7/7
◇Outline dimensions/Marking figure
ï¼µ24026
Ｌｏｔ Ｎｏ．
VCSP85H3
(UNIT : mm)
◇Cautions on use
(1) Absolute maximum ratings
If applied voltage, operating temperature range, or other absolute maximum ratings are exceeded, the LSI may be damaged. Do not apply voltages or
temperatures that exceed the absolute maximum ratings. If you expect that any voltage or temperature could be exceeding the absolute maximum
ratings, take physical safety measures such as fuses to prevent any conditions exceeding the absolute maximum ratings from being applied to the LSI.
(2) GND potential
Maintain the GND pin at the minimum voltage even under any operating conditions.
Actually check to be sure that none of the pins have voltage lower than that of GND pin, including transient phenomena.
(3) Thermal design
With consideration given to the permissible dissipation under actual use conditions, perform thermal design so that adequate margins will be provided.
(4) Short circuit between pins and malfunctions
To mount the LSI on a board, pay utmost attention to the orientation and displacement of the LSI. Faulty mounting to apply a voltage to the LSI may
cause damage to the LSI. Furthermore, the LSI may also be damaged if any foreign matters enter between pins, between pin and power supply, or
between pin and GND of the LSI.
(5) Operation in strong magnetic field
Make a thorough evaluation on use of the LSI in a strong magnetic field. Not doing so may malfunction the LSI.
REV. B