BD9130EFJ Datasheet, PDF (5/15 Pages) Rohm – Output 2A or More High-efficiency Step-down Switching Regulator with Built-in Power MOSFET

BD9130EFJ
Technical Note
●Information on advantages
Advantage 1：Offers fast transient response with current mode control system.
Conventional product (Load response IO=0.1A→0.6A)
BD9130EFJ (Load response IO=1A→2A)
VOUT
110mV
VOUT
29mV
IOUT
IOUT
Voltage drop due to sudden change in load was reduced by about 50%.
Fig.18 Comparison of transient response
Advantage 2： Offers high efficiency for all load range.
・For lighter load:
Utilizes the current mode control mode called SLLM^TM for lighter load, which reduces various dissipation such as
switching dissipation (P_SW), gate charge/discharge dissipation, ESR dissipation of output capacitor (P_ESR) and
on-resistance dissipation (P_RON) that may otherwise cause degradation in efficiency for lighter load.
Achieves efficiency improvement for lighter load.
・For heavier load:
Utilizes the synchronous rectifying mode and the low on-resistance
MOS FETs incorporated as power transistor.
ON resistance of P-channel MOS FET : 200mΩ(Typ.)
ON resistance of N-channel MOS FET : 160mΩ(Typ.)
100
SLLM^TM
②
50 _{① PWM}
①inprovement by SLLM system
②improvement by synchronous rectifier
0
0.001 0.01
0.1
1
Output current Io[A]
Achieves efficiency improvement for heavier load.
Offers high efficiency for all load range with the improvements mentioned above.
Fig.19 Efficiency
Advantage 3：・Supplied in smaller package due to small-sized power MOS FET incorporated.
・Output capacitor Co required for current mode control: 22µF ceramic capacitor
・Inductance L required for the operating frequency of 1 MHz: 2.2µH inductor
(BD9130EFJ:Co=22µF, L=2.2µH)
Reduces a mounting area required.
RITH
CITH
VCC
DC/DC
Convertor
Controller
Cin
L
VOUT
Co
15mm
CIN
RITH
L
10mm
CITH
CO
Fig.20 Example application
www.rohm.com
© 2009 ROHM Co., Ltd. All rights reserved.
5/14
2009.05 - Rev.A