BD9486F Datasheet, PDF (29/37 Pages) Rohm – 1ch Boost up type White LED Driver for large LCD

BD9486F
3.5.7 LED OCP Detection
Datasheet
STB
PWM
REG50
ISENSE
Abnormal
COUNTOR
SS
GATE
3.0V
3.0V
3.0V
3.0V
Smaller than
4count
4count
3.0V
3.0V
4count
0.4V
DIMOUT
RT ^2.0V
STATE
NORMAL LEDOCP NORMAL _LEDOCP Latch off Reset _{NORMAL LEDOCP}
abnormal
(*1)
(*2)
abnormal
(*3)
(*4) (*5)
(OFF)
(*6)
(*7)
abnormal
(*8)
Latch off
Figure 38. LED OCP Detection
(*1)…If ISENSE>3.0V, LEDOCP is detected, and GATE becomes L. To detect LEDOCP continuously, The DIMOUT is
compulsorily high, regardless of the PWM dimming signal.
(*2)…When the LEDOCP releases within 4 counts of the GATE frequency, the boost operation restarts.
(*3) …As the LEDOCP is detected again, the boost operation is stopped.
(*4)…If the LEDOCP detection continues up to 4 counts of GATE frequency. IC will be latched off.
(*5)…Once IC is latched off, the boost operation doesn't restart even if the LEDOCP releases.
(*6)…The latch off state can be reset by the STB=L.
(*7)…It normally starts by STB=L to H.
(*8)…The operation of the LEDOCP detection is not related to the logic of the PWM.
www.rohm.com
© 2013 ROHM Co., Ltd. All rights reserved.
TSZ22111・15・001
29/34
TSZ02201-0F1F0C100240-1-2
13.Feb.2014 Rev.004