MNR35 Datasheet, PDF (2/5 Pages) Rohm – Chip resistor networks

Resistors
MNR35
zCharacteristics
Item
Resistance
Variation of resistance
with temperature
Overload
Solderability
Resistance to
soldering heat
Rapid change of
temperature
Damp heat, steady state
Endurance at 70°C
Endurance
Resistance to solvent
Bend strength of
the end face plating
Guaranteed value
Resistor type
J : ±5%
Test conditions (JIS C 5201-1)
JIS C 5201-1 4.5
See Table.1
± (2.0%+0.1Ω)
A new uniform coating of minimum of
95% of the surface being immersed
and no soldering damage.
± (1.0%+0.1Ω)
No remarkable abnormality on the appearance.
± (1.0%+0.1Ω)
± (3.0%+0.1Ω)
± (3.0%+0.1Ω)
± (3.0%+0.1Ω)
± (1.0%+0.1Ω)
± (1.0%+0.05Ω)
Without mechanical damage such as breaks.
JIS C 5201-1 4.8
Measurement : −55 / +25 / +125°C
JIS C 5201-1 4.13
Rated voltage (current) ×2.5, 2s.
Maximum Overload Voltage : 100V
JIS C 5201-1 4.17
Rosin·Ethanol (25%WT)
Soldering condition : 235±5°C
Duration of immersion : 2.0±0.5s.
JIS C 5201-1 4.18
Soldering condition : 260±5°C
Duration of immersion : 10±1s.
JIS C 5201-1 4.19
Test temp. : −55°C to +125°C 5cyc
JIS C 5201-1 4.24
40°C, 93%RH
Test time : 1,000h to 1,048h
JIS C 5201-1 4.25.1
Rated voltage (current), 70°C
1.5h : ON − 0.5h : OFF
Test time : 1,000h to 1,048h
JIS C 5201-1 4.25.3
125°C
Test time : 1,000h to 1,048h
JIS C 5201-1 4.29
23±5°C, Immersion cleaning, 5±0.5min.
Solvent : 2-propanol
JIS C 5201-1 4.33
zExternal dimensions (Unit : mm)
∗_1.27
6.4±0.4
B
A
A'
R103
0.5±0.2
1.0±0.2
B'
0.8±0.2
Cross section A-A'
6
211
11
5
Cross section B-B' ^{6 1}
0.55±0.1
5
2 34
Material
Thick dielectric glaze of oxide metal
1 _{(only silver used for jumper)}
2 Thick film of silver for electrode
3 Nickel-coated electrode
4 External electrode coated with Sn
5 Alumina substrate
6 Overcoating
∗ Pitch of the upper electrode.
Rev.B
2/4