MNR35 Datasheet, PDF (1/5 Pages) Rohm – Chip resistor networks

Resistors
Chip resistor networks
MNR35 (1206×5 size)
MNR35
zFeatures
1) Common terminals yield area 40% smaller than that of the MNR38.
2) 8-element construction makes the MNR35 ideal for bus line pull-up / pull-down.
3) Convex electrodes
Easy to check the fillet after soldering is finished.
4) Compatible with a wide range of mounting equipment.
Squared corners make it excellent for mounting using image recognition devices.
5) ROHM resistors have approved ISO-9001 certification.
Design and specifications are subject to change without notice. Carefully check the specification sheet supplied with
the product before using or ordering it.
zRatings
Item
Rated power
Conditions
Power must be derated according to the power derating curve in
Figure 1 when ambient temperature exceeds 70°C.
100
80
60
40
20
0 _−55
0
70 100 125
AMBIENT TEMPERATURE (°C)
Fig.1
Specifications
0.063W (1 / 16W)
at 70°C
Rated voltage
The voltage rating is calculated by the following equation. If the value
obtained exceeds the limiting element voltage, the voltage rating
is equal to the maximum operating voltage.
E= P×R
Nominal resistance See Table 1.
Operating temperature
E: Rated voltage (V)
P: Rated power (W)
R: Nominal resistance (Ω)
Limiting element voltage
50V
−55°C to +125°C
Table 1
Resistance tolerance
J (±5%)
Resistance range
(Ω)
56≤R≤100k (E12)
Resistance temperature coefficient
(ppm / °C)
±200
•Before using components in circuits where they will be exposed to transients such as pulse loads (short-duration, high-level loads), be certain to evaluate the
component in the mounted state. In addition, the reliability and performance of this component cannot be guaranteed if it is used with a steady state voltage that
is greater than its rated voltage.
Rev.B
1/4