BU2050F_09 Datasheet, PDF (19/25 Pages) Rohm – Serial / Parallel 4-input Drivers

BU2050F,BU2092F,BU2092FV,BU2099FV,BD7851FP,BU2152FS
【BU2152FS】
●Pin descriptions
Pin
No.
Pin Name
I/O
Function
1
V_SS
-
Ground
2
CLK
I
Clock Input
3
V_SS
4
DATA
-
Ground
I
Serial Data Input
5～28 P1～P24
O
Parallel Data Output
29
SO
O
Cascade Output
30
STB
I
Strobe Signal Input active “L”
31
CLB
I
Clear Signal Input active “L”
32
V_DD
-
Power Supply
●Timing chart
CLK
DATA
STB
DATA24 DATA23 DATA22
DATA2
DATA1
Technical Note
Pn
Previous DATA
DATA
SO
Previous
DATA24
Previous
DATA23
Previous
DATA2
Previous
DATA1
DATA24
DATA23
DATA22
Fig. 18
1. After the power is turned on and the voltage is stabilized, STB should be activated, after clocking 24 data bits into
the DATA terminal.
2. Pn parallel output data of the shift register is set after the 24^th clock by the LCK.
3. Since the STB is a label latch, data is retained in the “H” section and renewed in the “L” section of the STB.
4. The final stage data of the shift register is outputted to the SO by synchronizing with the rise time of the CLOCK.
ï¼»Truth Tableï¼½
Input
CLK
STB
×
×
H
L
H
L
CLB
Function
L
All the data of the latch circuit are set to “H” (data of shift register does not
change), all the parallel outputs are “H”.
H
Serial data of DATA pin are latched to the shift register.
At this time, the data of the latch circuit does not change.
The data of the shift register are transferred to the latch circuit, and the data of
H
the latch circuit are outputted from the parallel output pin.
The data of the shift register shifts 1bit, and the data of the latch circuit and
parallel output also change.
www.rohm.com
© 2009 ROHM Co., Ltd. All rights reserved.
19/24
2009.06 - Rev.A