BU2365FV_08 Datasheet, PDF (12/17 Pages) Rohm – Clock Generator with Built-in VCXO for Audio/Video Equipments

●Audio Clock Functions
1) Output phase relation
The Audio clocks (i.e., CLK768FS, CLK384FS, and CLK512FS) of the BU2365FV are designed so that these clocks will
intentionally becomes out of the phase of each output, in order to provide low jitter and noise levels. Thus, overlapped
through currents generated at the clock edges can be suppressed to provide low jitter and noise levels.
For the generation of CLK384FS (18.432 MHz), generate two-phase CLK768FS (36.864 MHz) first. The CLK768FS1 and
CLK768FS2 will get to the phase relation with one clock out of the PLL2 output (VCO=147.456 MHz). By dividing the
frequency in sync with the leading edge of this CLK768FS1, the CLK384FS will fall out of the phase of the CLK768FS2.
Since the frequency of CLK512FS is divided into six portions in sync with the trailing edge of the PLL2 output, the
CLK512FS will fall out of the phases of CLK768FS and CLK384FS by half cycle.
As described above, the Audio clocks of the BU2365FV fall out of the phases each other, thus providing low jitter and
noise levels.
Furthermore, the true values of phase difference (Delay rate) between CLK384FS and CLK768FS are specified as shown
below with consideration given to variations in the measurements on the tests before shipment.
MIN
TYP
MAX
True value [nsec]
17.0
20.0
23.0
BU2365FV
CLK768FS1：36.864MHz(inside)
PLL2
DQ
QB
VCO　147.456MHz
DQ
QB
DQ
QB
CLK384FS：18.432MHz
CLK768FS2：36.864MHz output
PLL2：147.456MHz
CLK768FS1：36.864MHz
CLK768FS2：36.864MHz
CLK384FS：18.432MHz
Delay
CLK512FS：24.576MHz
Fig.79 Audio Clock Output Circuit Configuration and Timing Chart
2) Half-pulse clock protection [HPC]
The CLK768FS output is provided with a function used to prevent the occurrence of asynchronous droop of half cycle or less (i.e.,
half-pulse clock) while in frequency selection under the FSEL pin control.
This function is designed to set the frequency to output L fixed after the elapse of two trailing clocks of output before the selection
and to a desired frequency after the elapse of two trailing clocks of output after the selection, when switching the FSEL pin.
Specifically speaking, when the FSEL pin is set to High, the CLK768FS outputs a frequency of 36.864 MHz. With this setting, if the
FSEL pin is switched to Low, the CLK768FS will be set to L Fixed after the lapse of two trailing clocks of 36.864 MHz, and then the
CLK768FS will output a frequency of 33.8688 MHz after the lapse of two trailing clocks of 33.8688 MHz.
FSEL
H/L　change
H/L　change
36.864MHz
①②
①②
33.8688MHz
①
②
①
②
CLK768FS output
36.864Hz output
Output：L
33.8688MHz output
Fig.80 HPC timing chart
output：L
36.864MHz output
12/16