RV5C348A-E2-F Datasheet, PDF (33/47 Pages) RICOH electronics devices division – 4-wire Serial Interface

RT5C348B (TSSOP10G) and RS5C348B (SSOP10) are the discontinued products. As of July in 2016.
Rx5C348A/B
Voltage Monitoring Circuit
The supply monitoring circuit is configured to conduct a sampling operation during an interval of 7.8ms per
second to check for a drop in supply voltage below a threshold voltage of 2.1 or 1.6v for the VDSL bit setting of 0
(the default setting) or 1, respectively, in the Control Register 2, thus minimizing supply current requirements as
illustrated in the timing chart below. This circuit suspends a sampling operation once the VDET bit is set to 1 in
the Control Register 2. The supply voltage monitor is useful for back-up battery checking.
VDD
XSTP _Internal
initialization
period
1s
(1 to 2sec.)
Sampling timing for
VDD supply voltage
VDET
(D6 in Address Fh)
XSTP←0
VDET←0
7.8ms
2.1v or 1.6v
VDET←0
<Precautions for Using Voltage Monitoring Circuit>
After writing to the second counter, reset a VDET flag (writing 0) once for defining a value of VDET flag.
12345
- 33 -