DS-FIRETRAP-5 Datasheet, PDF (4/6 Pages) rfsolutions.ltd – Supplied ready to operate the FIRE-TRAP system is designed for continu-ous operation 365 days of the year.

‘FIRETRAP’ Radio Release
Additional Transmitters
Each transmitter has a unique identity. Each time a transmitter switch is operated, it transmits a se-
cure RF signal. The Receiver can to set learn this signal and pair it to any of its outputs.
To pair a New Transmitter switch follow this procedure:
Any transmitter button can be paired to one or many of the receiver output relays.
Each button must be paired to each relay individually by following this procedure:
Select the receiver output relay to pair:
1. Briefly press the receiver pairing switch (S2) once
2. The Receiver pairing LED will flash once to indicate output relay 1 is selected
3. After the Receiver pairing LED stops flashing, press the receiver pairing switch again to
select the next relay
4. Repeat step 2 until the required output relay is selected.
5. Press the button on the transmitter you want to pair to the selected relay.
6. The receiver pairing LED will Flash once to confirm pairing is complete
Erasing Receivers Memory
1. Press and hold the receiver pairing switch for approx 10 seconds.
2. Release the switch and watch for the receiver LED to flash to confirm erasing.
3. Press a button on the transmitter and ensure no relay actives
NOTE: You cannot erase individual transmitters or buttons
Configuring Receiver Relays
The link caps (shown above) configure the outputs operation. The these links are connected/broken using
the small link cap placed over the pins. To “store” the setting turn power off then back on.
Link Positions
LK1
LK2
Open
Closed
Open
Open
Open
Closed
Closed
Closed
RLY 1
1_{/2 sec Mom}
1_{/2 sec Mom}
Mom
-
Relay Outputs
RLY 2
RLY 3
1_{/2 sec Mom} 1_{/2 sec Mom}
Mom
Mom
Mom
Mom
-
-
RLY 4
1_{/2 sec Mom}
Mom
Mom
-
DS FIRETRAP-5
©2009 REG No 277 4001, Lewes, England. Page 4