DS-FIRETRAP-5 Datasheet, PDF (3/6 Pages) rfsolutions.ltd – Supplied ready to operate the FIRE-TRAP system is designed for continu-ous operation 365 days of the year.

‘FIRETRAP’ Radio Release
PLEASE READ BEFORE ATTEMPTING INSTALLATION:
This system is supplied complete with cable in order to connect to the Clay Trap Release.
Warning : Not all Clay Traps have the same wiring convention!
The system is pre-wired (as diagram below) to operate with most trap releases, before connecting, CHECK
YOUR CONNECTIONS. (using a voltmeter) if you are in any doubt, DO NOT CONNECT THE SYSTEM, consult a
qualified Electrician. Although the system operates on 12-30V DC damage may occur to the receiver unit if
wrong connections are made.
Installation Notes
An ideal installation would be to firmly fix the FIRETRAP-RX approx. 2 metres from the ground, in direct sight
of the transmitter. Lowering the height or having obstacles between transmitter and receiver will reduce
range!
Connecting Power to the Receiver unit.
The receiver unit requires the following connections
to operate
- 12V supply (Brown wire as supplied)
- OV Supply (Yell/GRN wire as supplied)
When the Receiver unit has power connected the
Power LED will illuminate. This must be ‘on’ for the
system to operate.
Check the Wiring required for your Trap:
The FIRETRAP is capable of switching nearly any trap
type, however wiring conventions vary between
manufacturers. The relays on the FIRETRAP can
switch up to 24V DC or 230V AC @ 5A.
.
Note:
If you are pairing multiple transmitter ie. If you have
purchased receivers and transmitters separately.
Follow the procedure detailed on page 4 to configure
your chosen system. FIRETRAP-S1 systems are sold
pre-paired.
Alternative Wiring :
The switched output may be connected in several
ways, please see the ‘Relay Output Connections
section. If in doubt consult a qualified electrician.
DS FIRETRAP-5
©2009 REG No 277 4001, Lewes, England. Page 3