DS-ELITE-1 Datasheet, PDF (4/8 Pages) rfsolutions.ltd – Whatever your switching application the ELITE Remote control system with 4 individual 230V outputs and it’s completely waterproof IP68 enclosure will be a great choice.

ELITE Remote control System
Quick Installation Guide (systems only)
The Elite system provides 4 switches each capable of switching up to 1KW (4A @ 230V). Each channel is inde-
pendent and separately fused. The ELITE Remote control system provides 230V mains switched outputs via
each terminal.
1. First mount the ELITE system receiver box in the wall in your desired location (see Page 7 for wall
mounting dimensions and information).
2. Open the enclosure by removing fixing screws from the enclosure front and then removing the front
from the enclosure.
3. Wire the LIVE Neutral and Earth connections to the power supply screw terminal as shown below
(shown as A).
4. Wire your load(s) as required (shown as B)
5. Once all required wiring is complete, use the handheld ELITE transmitter to switch the outputs on and
off.
6. As supplied the handheld will operate the outputs - Button 1 to output 1, Button 2 to output 2 etc.
7. All buttons will operate in a latching mode - Press for on, press again for off. It is possible to change the
operation to momentary mode by fitting the links (shown as C)
8. For advanced operation such as adding extra transmitters different button mapping options see ad-
vanced operation section.
Fig 1.1
DS-ELITE-1
PAGE 4