204PRO4-433F Datasheet, PDF (3/6 Pages) rfsolutions.ltd – Professional Radio Control

Professional Radio Control
1 Pre-Configuring the Remote Control System
PRO
Series
There are three Steps:
1. Pre-Configure the 210Rx to operate with a type of Transmitter (e.g. the 204 range or 205 range)
2. Map the Transmitter(s) switch(es) to the 210Rx output(s)
3. Set the 210Rx outputs to be latching, momentary or timed.
1.1 Pre-Configure the 210Rx to operate with a Transmitter Series
1. Ensure option link J8 is open.
2. Apply power to the 210Rx, All output LEDS flash alternately. This is factory reset default state.
3. Briefly Press any switch on the transmitter.
The 210Rx will now confirm this by flashing LED 1 to show it is configured for use with a handheld
transmitter.
Note This will now happen at each power on.
DS200PRO-3 June ’07
©2007 RF Solutions Ltd, www.rfsolutions.co.uk Page 3