RF5146_1 Datasheet, PDF (6/13 Pages) RF Micro Devices – QUAD-BAND GSM850/GSM900/DCS/PCS POWER AMP MODULE

RF5146
Parameter
Specification
Min.
Typ.
Max.
Overall (PCS Mode)
Operating Frequency Range
Maximum Output Power
+32.0
1850 to 1910
+30.0
Total Efficiency
Input Power Range
Output Noise Power
52
0
+3
+5
-85
Forward Isolation 1
Forward Isolation 2
Second Harmonic
Third Harmonic
All Other
Non-Harmonic Spurious
Input Impedance
Input VSWR
Output Load VSWR Stability
-40
-20
-15
-20
50
8:1
Output Load VSWR Ruggedness
10:1
Output Load Impedance
50
Power Control V_RAMP
Power Control Range
50
Notes:
V_RAMP_R_P=V_RAMP set for 32dBm at nominal conditions.
-36
2.5:1
Unit
MHz
dBm
dBm
%
dBm
dBm
dBm
dBm
dBm
dBm
dBm
Ω
Ω
Condition
Temp=25°C, V_BATT=3.5V,
V_RAMP =1.6V, P_IN=3dBm, Freq=1850MHz to
1910 MHz,
25% Duty Cycle, pulse width=1154μs
Temp=25°C, V_BATT=3.5V,
V_RAMP=1.6V, 1850MHz to 1910MHz
Temp=+85°C, V_BATT=3.0V,
V_RAMP = 1.6 V
At P_{OUT MAX,} V_BATT=3.5V
Full output power guaranteed at minimum
drive level
RBW=100kHz, 1930MHz to 1990MHz, P_OUT
> 0dBm, V_BATT=3.5V
TX_ENABLE=Low, P_IN=+5dBm
TXEnable=High, V_RAMP=0.2V, P_IN=+5dBm
V_RAMP=0.2V to V_{RAMP_}R_P
V_RAMP=0.2V to V_{RAMP_}R_P
V_RAMP=0.2V to 1.6V
V_RAMP=0.2V to 1.6V
Spurious<-36dBm, RBW=3MHz
Set V_RAMP where P_OUT<32dBm into 50 Ω load
Set V_RAMP where P_OUT<32dBm into 50Ω load.
No damage or permanent degradation to part.
Load impedance presented at RF OUT pin
dB
V_RAMP=0.2V to 1.6V, P_IN=+5dBm
6 of 18
7628 Thorndike Road, Greensboro, NC 27409-9421 · For sales or technical
support, contact RFMD at ([phone] or [e-mail].
Rev A1 DS050928