RFPA0133_12 Datasheet, PDF (5/9 Pages) RF Micro Devices – 5V PROGRAMMABLE GAIN HIGH EFFICIENCY POWER AMPLIFIER

RFPA0133
Pin
1,4,5,
7,8,
11, 15
2
3
6
9,10
12
13
14
16
Function
NC
GND
RF IN
VPD
RF
OUT/VCC2
G8
G16
VCC1
VBIAS
Description
These pins may be left unconnected or soldered to ground.
Ground connection. Keep traces physically short and connect immediately to the ground plane for best perfor-
mance.
Amplifier RF input. The amplifier does not contain internal DC blocking and, therefore, should be externally DC
blocked before connecting to any device which has DC present or which contains a DC path to ground.
Power down control voltage. When this pin is at 0V, the device will be in power down mode, dissipating minimum
DC power. When this pin is at 3V the device will be in full power mode delivering maximum gain and output
power capability. This pin should not, in any circumstance, be higher than 3.3V. This pin should also have an
external UHF and HF bypassing capacitor. Typically V_BIAS=V_PD=3.0V.
Amplifier RF output. This is an unmatched collector output of the final amplifier transistor. Bias for the final
power amplifier output transistor must also be provided through one of these pins. Pins 9 and 10 should be
used for the RF output with a matching network that presents the optimum load impedance to the PA for maxi-
mum power and efficiency, as well as providing DC blocking at the output.
RF output power gain control 8dB bit (see specification table for logic). The control voltage at this pin should
never exceed 3.3V and a logic high should be at least 1.7V. This pin should also have an external UHF bypassing
capacitor. See note.
RF output power gain control 16dB bit (see specification table for logic). The control voltage at this pin should
never exceed 3.3V and a logic high should be at least 1.7V. This pin should also have an external UHF bypassing
capacitor. See note.
Positive supply for the first stage (driver) amplifier. This is an unmatched transistor collector output.
Positive supply for the bias circuits. This pin should be bypassed with a single UHF capacitor, placed as close as
possible to the package. Typically, V_BIAS=V_PD=3.0V.
Note: The 8dB and 16dB gain steps are approximate for small signal operation. As the device compresses, the values of the
gain steps compress as well. The output power table on page two shows the effect of the gain steps for saturated (0dBm input)
operation.
DS120206
7628 Thorndike Road, Greensboro, NC 27409-9421 · For sales or technical
support, contact RFMD at ([phone] or [e-mail].
5 of 9