RFCM5304 Datasheet, PDF (2/7 Pages) RF Micro Devices – INTEGRATED AMPLIFIER

RFCM5304
Absolute Maximum Ratings
Parameter
DC Supply Over-Voltage (5 minutes)
Storage Temperature
Operating Mounting Base Temperature
Moisture Sensitivity Level IPC/JEDEC J-STD-20
Rating
14
-40 to +100
-30 to +110
MSL 3 @260
Unit
V
°C
°C
°C
Caution! ESD sensitive device.
RoHS status based on EU Directive
2011/65/EU
Exceeding any one or a combination of the Absolute
Maximum Rating conditions may cause permanent
damage to the device. Extended application of Absolute
Maximum Rating conditions to the device may reduce
device reliability. Specified typical performance or
functional operation of the device under Absolute
Maximum Rating conditions is not implied.
Nominal Operating Parameters
Parameter
Specification
Min
Typ Max
General Performance
Power Gain
Slope ^[1]
Flatness of Frequency Response
Input Return Loss
Output Return Loss
Noise Figure
Total Current Consumption (DC)
Attenuator
Attenuator Range
Power Enable/Disable
38.5
39.2
40.5
38.3
41.2
-0.2
1.2
1.0
20
18
20
18
2.5
2.8
2.9
3.2
3.2
3.5
205
220
0 to 20
Amp
enabled
Amp
disabled
Unit
Condition
V+= 12V; TMB=30°C; ZS=ZL=75Ω; Att=0dB
dB
f=5MHz
dB
f=220MHz
dB
f=5MHz to 220MHz
dB
f=5MHz to 220MHz (Peak to Valley)
dB
f=5MHz to 200MHz
dB
f=200MHz to 220MHz
dB
f=5MHz to 200MHz
dB
f=200MHz to 220MHz
dB
f=10MHz
dB
f=100MHz
dB
f=220MHz
mA
V+= 12V; TMB=30°C; ZS=ZL=75Ω;
dB
Attenuator Voltage 0V to 12V
Logic high (3.3V) applied to power enable pin ^[2]
Logic low (0V) applied to power enable pin ^[3]
RF Micro Devices Inc. 7628 Thorndike Road, Greensboro, NC 27409-9421
DS150319
For sales or technical support, contact RFMD at +1.336.678.5570 or [e-mail].
The information in this publication is believed to be accurate. However, no responsibility is assumed by RF Micro Devices, Inc. ("RFMD") for its use, nor for any infringement of patents or other rights of
third parties resulting from its use. No license is granted by implication or otherwise under any patent or patent rights of RFMD. RFMD reserves the right to change component circuitry, recommended
application circuitry and specifications at any time without prior notice.
2 of 7