RWP03160-10 Datasheet, PDF (3/5 Pages) RFHIC – Wideband Power Amplifier

Wideband Power Amplifier
RWP03160-10
Typical Performance @ 25°C
N^th Harmonic
Current Current Current Gp
PAE
Frequency P1dB P3dB Psat _{@P1dB @P3dB @Psat @ P3dB @ P3dB}
@Po = P1dBm
OIP3
@40dBm/Tone
2^nd Har 3^rd Har
(MHz) (dBm) (dBm) (dBm) (A)
(A)
(A)
(dB)
(%)
(dBc)
(dBm)
20
48.1 51.0 52.3 6.60
8.30
8.9
39.50 54.17 -43.2 -23.1
56.6
100
48.1 52.1 53.0 7.08 10.18
11.1 40.10 56.90 -40.0 -20.6
56.5
200
48.2 52.3 53.0 7.30 11.04
12.0 40.70 54.94 -46.1 -23.1
56.2
300
48.0 51.1 52.1 7.01
9.73
11.1 40.90 47.29 -35.2 -24.9
55.4
400
48.0 51.2 52.0 7.13
9.07
9.9
40.90 51.91 -38.9 -42.9
55.3
500
48.0 52.0 52.4 7.57 10.98
11.0 40.20 51.55 -57.9 -45.9
54.4
Precautions
1. This product is designed to be used for broadband amplification.
Heat generation is higher when there is no RF signal in the device.
Therefore, the worst case scenario is when there is no RF signal, and the amplifier is “on” with current draw.
The temperature must be calculated properly.
Case temperature must maintain below 80°C.
2. Thermal Grease or Metal Thermal Interface Materials are recommended for heat dissipation.
An example would be spreading thermal grease on the bottom of the device
Korean Facilities : 82-31-250-5078 / [e-mail]
US Facility : 919-677-8780 / [e-mail]
3/5
All specifications may change without notice
Version 1.7