R1EX24016ASAS0I_12 Datasheet, PDF (9/19 Pages) Renesas Technology Corp – Two-wire serial interface 16k EEPROM

R1EX24016ASAS0I/R1EX24016ATAS0I
Device Addressing
The EEPROM device requires an 8-bit device address word following a start condition to enable the chip for a read or a
write operation. The device address word consists of 4-bit device code, 3-bit device address code and 1-bit
read/write(R/W) code. The most significant 4-bit of the device address word are used to distinguish device type and
this EEPROM uses “1010” fixed code. The device address code is followed by the 3-bit memory address in the order
of a10, a9, a8.
The eighth bit of the device address word is the read/write(R/W) bit. A write operation is initiated if this bit is low and
a read operation is initiated if this bit is high.
The EEPROM turns to a stand-by state if the device code is not “1010”.
Device Address Word
Device code (fixed)
16k
1
0
1
Note: 1. R/W=“1” is read and R/W = “0” is write.
Device address word (8-bit)
Device address code
0
a10
a9
a8
R/W code*¹
R/W
R10DS0107EJ0100 Rev.1.00
Feb. 23, 2012
Page 9 of 17