PD8835_15 Datasheet, PDF (7/24 Pages) Renesas Technology Corp – 7300 PIXELS × 3 COLOR CCD LINEAR IMAGE SENSOR

μ PD8835
ABSOLUTE MAXIMUM RATINGS
Parameter
Symbol
Ratings
Unit
Output drain voltage
VOD1, VOD2
–0.3 to +12.0
V
Digital power supply
VDD
–0.3 to +8.0
V
Substrate voltage
VSUB
–0.3 to +8.0
V
Heat sink VDD
HS-VDD
–0.3 to +8.0
V
Voltage difference between VDD and VSUB
VDD-VSUB
–0.5 to +0.5
V
Shift register clock voltage
Last stage shift register clock voltage
Reset gate clock voltage
Vφ1, Vφ2
Vφ 2L
Vφ R
–0.3 to +8.0
V
–0.3 to +8.0^{Note 1}
V
–0.3 to +8.0 ^{Note 1}
V
Transfer gate clock voltage
Note 2
Operating ambient temperature
Note 3
Package surface temperature
Storage temperature
Vφ TG
TA
Tpkg
Tstg
–0.3 to +8.0
V
0 to +60
˚C
0 to +75
˚C
–40 to +100
˚C
Notes 1. Be careful so that the voltage of Vφ 2L and Vφ R are not beyond VDD + 0.3V.
2. The operating ambient temperature TA is defined as an atmosphere temperature in a point 10 mm
away on the circuit board, and 10 mm away from the short side of package pin 1. Refer to the below figure.
3. The package surface temperature Tpkg is defined as a surface temperature of package short side of pin1.
Refer to the below figure.
TA
Tpkg
Pin1
10 mm
10 mm
Caution
Product quality may suffer if the absolute maximum rating is exceeded even momentarily for any
parameter. That is, the absolute maximum ratings are rated values at which the product is on the
verge of suffering physical damage, and therefore the product must be used under conditions that
ensure that the absolute maximum ratings are not exceeded.
RECOMMENDED POWER ON/OFF SEQUENCE
The power on/off sequence is not limited. But, when VOD1 and VOD2 are powered, avoid VSUB and VDD being
unsettled (i.e. high impedance).
Prevent VDD and VSUB from being powered on/off separately.
Data Sheet S20220EJ1V0DS
5