HD404889_03 Datasheet, PDF (58/197 Pages) Renesas Technology Corp – Low-Voltage AS Microcomputers with On-Chip LCD Circuit

HD404889/HD404899/HD404878/HD404868 Series
interrupt request, the mode transition depends on the value of the LSON bit: the MCU enters active mode if
LSON = 0, and enters subactive mode if LSON = 1. In the case of a transition to active mode, interrupt
request generation is delayed to secure the oscillation settling time: the delay is the tRC set time for the
timer
A
interrupt,
and,
for
the
INT
0
interrupt
or
WU
0
to
WU
3
interrupt,
Tx
(T
+
t_RC
<
Tx
<
2T
+
t_RC)
if
bit
1
and 0 (MIS1, MIS0) of the miscellaneous register are set to 00, or Tx (t_RC < Tx < T + t_RC) if MIS1 and MIS0
are set to 01 or 10 (figures 16 and 17). Other operations when the transition is made are the same as when
watch mode is cleared (figure 14).
Subactive mode:
In subactive mode, the OSC₁ and OSC₂ oscillator circuits stop and the MCU operates on clocks generated
by the X1 and X2 oscillator circuits. In this mode, functions other than the A/D converter operate, but
since the operating clocks are slow, power consumption is the lowest after watch mode.
A CPU instruction processing speed of 244 µs or 122 µs can be selected according to whether bit 2 (SSR2)
of the system clock select register (SSR: $004) is set to 1 or cleared to 0. The value of the SSR2 bit should
be changed (0→1 or 1→0) only in active mode. If the value is changed in subactive mode, the MCU may
operate incorrectly.
Subactive mode is cleared by executing a STOP/SBY instruction. A transition is then made to either watch
mode or active mode according to the value of the low speed on flag (LSON: $020,0) and the direct transfer
on flag (DTON: $020,3).
Subactive mode is a function option, and should be specified in the function option list.
Interrupt frame:
In
watch
mode
and
subactive
mode,
ø_CLK
is
supplied
to
the
timer
A,
WU
0
to
WU₃,
and
INT
0
acceptance
circuits. Prescaler W and timer A operate as time bases, and generate interrupt frame timing. Either of two
values can be selected for the interrupt frame period, T, by means of the miscellaneous register (MIS: $005)
(figure 17).
In watch mode and subactive mode, the timing for generation of timer A,INT₀ and WU₀ to WU₃ interrupts
is synchronized with the interrupt frame. Except for the case of an active mode transition, the interrupt
strobe timing is used for interrupt request generation. Timer A generates overflow and interrupt requests at
the interrupt strobe timing.
Rev.6.00, Sep.08.2003, page 58 of 197