RX630 Datasheet, PDF (4/8 Pages) Renesas Technology Corp – Renesas Starter Kit Sample

RX630
Renesas Starter Kit Sample Code for CubeSuite+
6. Setting Properties of the Debug Tool
Before connecting the E1 emulator, open the Property panel by double-clicking on RX E1(JTAG) (debug tool) in the
Project Tree then set [Main clock frequency] and [Supply voltage] on the [Connect Settings] tabbed page.
In this project, the settings below have already made.
Select [No] for [Power target from the emulator] if an external power supply is to be provided to the target board.
Table Properties Settings of the CubeSuite+ Project for RX630 [RX E1(JTAG)]
Tab
Connect Settings
Category
Clock
Connection with
Target Board
Item
Main clock frequency
[MHz]
Power target from the
emulator
(MAX 200 mA)
Supply voltage
Setting
12
Yes
3.3 V
7. Building a Program
Selecting [Build] -> [Build Project] makes CubeSuite+ build the project. The results obtained by building the project
are displayed in the Output panel.
8. Starting the E1 Emulator
Connect the E1 emulator to the Renesas Starter Kit.
Refer to the documentation accompanying the Renesas Starter Kit for the settings of switches on the board for the kit
and connection with the E1 emulator.
Select [Debug] -> [Download] from the menu.
The E1 emulator is started and downloads the program.
R20AN0276EJ0100 Rev. 1.00
Jan. 17, 2014
Page 4 of 6