English
Language : 

HA13173H Datasheet, PDF (21/24 Pages) Renesas Technology Corp – Multiple Voltage Regulator for Car Audio
HA13173H
8. Header of IC (TAB) have to connect to GND.
For mounting the header of IC on the heat sink with the screw, heat sink have to connect to GND. When header of
IC mount with heat sink with holding parishes conductive material, holding parts have to connect to GND. At this
time, the holding parts mount with heat sink with the screw, or it must connect to header of IC. If users have
question or request, please contact the vendor.
Example of Recommendation about the Method of Connecting Header of IC to GND
Bad example
There is a crevice or
the insulator is inserted.
NG
NG
NG
Header of IC and GND
are not connected.
Header of IC is not
connected to GND.
There is no heat sink.
9. Soldering should be done within the soldering heat test standard of the IC, specifying that the lead wires, up to 1 to
1.5 mm off the IC body, are kept in solder at 260°C for 10 seconds (2 or less times) and at 350°C for 3 seconds.
Therefore give careful consideration in order to do not exceed the condition. In a soldering iron is used, use a
soldering iron grounded and do not leak at the tip.
Characteristics
1. When there may be the mode which VB, VBUP or GND, and each output reverse with a normal potential state in
application, it recommends attaching a diode for IC protection. When outputting the terminal of IC to the direct set
exterior, a diode is required in order to protect IC from incorrect contact on a battery and a GND line. Especially
EXTOUT is required.
2. In the parts shown in external part lineup, the value of a capacitor is the minimum value required in order to secure
the oscillation stability of IC. Please use the capacitor independent of temperature and bias. Moreover, please use
the capacitor whose ESR is 10 Ω or less in the operating temperature range.
Rev.1.00 Jan 16, 2007 page 21 of 23