R1EX24032ASAS0A Datasheet, PDF (20/24 Pages) Renesas Technology Corp – Two-wire serial interface 32k EEPROM (4-kword × 8-bit)

R1EX24032AxxS0A
Notes
Data Protection at V_CC On/Off
When V_CC is turned on or off, noise on the SCL and SDA inputs generated by external circuits (CPU, etc)
may act as a trigger and turn the EEPROM to unintentional program mode. To prevent this unintentional
programming, this EEPROM has a power on reset function. Be careful of the notices described below in
order for the power on reset function to operate correctly.
• SCL and SDA should be fixed to V_CC or V_SS during V_CC on/off. Low to high or high to low transition
during V_CC on/off may cause the trigger for the unintentional programming.
• V_CC should be turned off after the EEPROM is placed in a standby state.
• V_CC should be turned on from the ground level(V_SS) in order for the EEPROM not to enter the
unintentional programming mode.
• V_CC turn on speed should be longer than 10 µs.
Noise Suppression Time
This EEPROM have a noise suppression function at SCL and SDA inputs, that cut noise of width less than
50 ns. Be careful not to allow noise of width more than 50 ns.
REJ03C0345-0100 Rev.1.00 Apr. 21, 2008
Page 20 of 22