R1EV24004ASAS0I_15 Datasheet, PDF (12/17 Pages) Renesas Technology Corp – Two-wire serial interface 4k EEPROM (512-word  8-bit)

R1EV24004ASAS0I
Read Operation
There are three read operations: current address read, random read, and sequential read. Read operations are initiated
the same way as write operations with the exception of R/W = “1”.
Current Address Read:
The internal address counter maintains the last address accessed during the last read or write operation, with
incremented by one. Current address read accesses the address kept by the internal address counter. After receiving a
start condition and the device address word (R/W is “1”), the EEPROM outputs the 8-bit current address data from the
most significant bit following acknowledgment “0”. If the EEPROM receives acknowledgment “1” (no
acknowledgment) and a following stop condition, the EEPROM stops the read operation and is turned to a standby state.
In case the EEPROM has accessed the last address of the last page at previous read operation, the current address will
roll over and returns to zero address. In case the EEPROM has accessed the last address of the page at previous write
operation, the current address will roll over within page addressing and returns to the first address in the same page.
The current address is valid while power is on. The current address after power on will be indefinite. The random read
operation described below is necessary to define the memory address.
Current Address Read Operation
Device
address
Read data (n+1)
4k
1 0 1 0 1*R
Start
ACK No ACK
R/W
Note :1*Don't care bit
Stop
R10DS0123EJ0100 Rev.1.00
Apr. 08, 2013
Page 12 of 15