R0E00008AKCE00EP9 Datasheet, PDF (11/23 Pages) Renesas Technology Corp – Microcomputer Development Environment System

E8a Emulator
Section 6 Notes on Using the E8a Emulator
Section 6 Notes on Using the E8a Emulator
1. Program area for the E8a emulator
Table 6.1 lists the program areas allotted for the E8a emulator. Do not change this area allocation, otherwise the
E8a emulator will not control the MCU. If settings were changed, disconnect the debugger and then reconnect it.
Table 6.1 Program Area for the E8a Emulator
Group
R8C/18
Part No.
R5F21181
R5F21182
R5F21183
R5F21184
ROM Size
Programming
Area
4 KB
8 KB
12 KB
16 KB
Data
Area
-
-
-
-
R8C/19
R5F21191
R5F21192
R5F21193
R5F21194
4 KB
8 KB
12 KB
16 KB
2 KB
2 KB
2 KB
2 KB
R8C/1A
R5F211A1
R5F211A2
R5F211A3
R5F211A4
R8C/1B
R5F211B1
R5F211B2
R5F211B3
R5F211B4
4 KB
8 KB
12 KB
16 KB
4 KB
8 KB
12 KB
16 KB
-
-
-
-
2 KB
2 KB
2 KB
2 KB
Note:
Program Area for E8a Emulator
Vector Area
FFE4h - FFE7h,
FFE8h - FFEBh,
FFECh - FFEFh,
FFF4h - FFF7h,
FFF8h - FFFBh,
FFFCh - FFFEh
ROM Area
(Default Area)
-
-
-
2 KB of the ROM area [*1]
(User Flash Area C000h - C7FFh)
-
-
-
2 KB of the ROM area [*1]
(Data Flash Area 2400h - 2BFFh)
or
(User Flash Area C000h - C7FFh)
-
-
-
2 KB of the ROM area [*1]
(User Flash Area C000h - C7FFh)
-
-
-
2 KB of the ROM area [*1]
(Data Flash Area 2400h - 2BFFh)
or
(User Flash Area C000h - C7FFh)
1. When using the MCU types R5F21184, R5F21194, R5F211A4 or R5F211B4, the [Emulator Setting] dialog
box shown in Figure 6.1 is displayed. Specify the area which will not be used by the user system. If the
[Enable advanced setting] check box is checked, the area used by the emulator can be specified with the
address (Figure 6.2).
REJ10J1646-0200 Rev.2.00 Jun. 17, 2009
Page 8 of 18