HYS72T64000HR-3S-B Datasheet, PDF (4/52 Pages) Qimonda AG – 240-Pin Registered DDR2 SDRAM Modules

Internet Data Sheet
HYS72T[64/128/256]xxxHR–[3S/3.7/5]–B
240-Pin Registered DDR2 SDRAM
1.2
Description
The QIMONDA HYS72T[64/128/256]xxxHR–[3S/3.7/5]–B
module family are Registered DIMM modules with 30 mm
height based on DDR2 technology. DIMMs are available as
ECC modules in 64M × 72 (512 MB), 128M × 72 (1GB ),
256M × 72 (2GB) organization and density, intended for
mounting into 240-Pin connector sockets.
The memory array is designed with 512-Mbit Double-Data-
Rate-Two (DDR2) Synchronous DRAMs. All control and
address signals are re-driven on the DIMM using register
devices and a PLL for the clock distribution. This reduces
capacitive loading to the system bus, but adds one cycle to
the SDRAM timing. Decoupling capacitors are mounted on
the PCB board. The DIMMs feature serial presence detect
based on a serial E²PROM device using the 2-pin I²C
protocol. The first 128 bytes are programmed with
configuration data and the second 128 bytes are available to
the customer.
Product Type¹⁾
Compliance Code²⁾
TABLE 2
Ordering Information for RoHS Compliant Products
Description
SDRAM Technology
PC2–5300
HYS72T64000HR–3S–B
512 MB 1Rx8 PC2-5300R-555-12-A0
1 Rank ECC
512 Mbit (×8)
HYS72T128000HR–3S–B
1 GB 1Rx4 PC2-5300R-555-12-C0
1 Rank ECC
512 Mbit (×4)
HYS72T128020HR–3S–B
1 GB 2Rx8 PC2-5300R-555-12-B0
2 Ranks, ECC 512 Mbit (×8)
HYS72T256220HR–3S–B
2 GB 2Rx4 PC2-5300R-555-12-J1
2 Ranks, ECC 512 Mbit (×4)
PC2–4200
HYS72T64000HR–3.7–B
512 MB 1Rx8 PC2-4200R-444-12-A0
1 Rank ECC
512 Mbit (×8)
HYS72T128000HR–3.7–B
1 GB 1Rx4 PC2-4200R-444-12-C0
1 Rank ECC
512 Mbit (×4)
HYS72T128020HR–3.7–B
1 GB 2Rx8 PC2-4200R-444-12-B0
2 Ranks, ECC 512 Mbit (×8)
HYS72T256220HR–3.7–B
2 GB 2Rx4 PC2-4200R-444-12-J1
2 Ranks, ECC 512 Mbit (×4)
PC2–3200
HYS72T64000HR–5–B
512 MB 1Rx8 PC2-3200R-333-12-A0
1 Rank ECC
512 Mbit (×8)
HYS72T128000HR–5–B
1 GB 1Rx4 PC2-3200R-333-12-C0
1 Rank ECC
512 Mbit (×4)
HYS72T128020HR–5–B
1 GB 2Rx8 PC2-3200R-333-12-B0
2 Ranks, ECC 512 Mbit (×8)
HYS72T256220HR–5–B
2 GB 2Rx4 PC2-3200R-333-12-J1
2 Ranks, ECC 512 Mbit (×4)
1) All Product Type numbers end with a place code, designating the silicon die revision. Example: HYS72T64000HR–3.7–B, indicating Rev.
“B” dies are used for DDR2 SDRAM components. For all QIMONDA DDR2 module and component nomenclature see Chapter 6 of this
data sheet.
2) The Compliance Code is printed on the module label and describes the speed grade, for example “PC2–4200R–444–12–A0”, where
4200R means Registered DIMM modules with 4.26 GB/sec Module Bandwidth and “444-12” means Column Address Strobe (CAS)
latency = 4, Row Column Delay (RCD) latency = 4 and Row Precharge (RP) latency = 4 using the latest JEDEC SPD Revision 1.2 and
produced on the Raw Card “A”.
Rev. 1.2, 2007-01
4
03292006-JXZQ-CG6T