CS10.481 Datasheet, PDF (8/26 Pages) PULS GmbH – 48V, 5A, SINGLE PHASE INPUT

C-Line
CS10.481
48V, 5A, SINGLE PHASE INPUT
6. OUTPUT
Output voltage
nom. 48V
Adjustment range
min. 48-52V
guaranteed
max. 56V^***)
at clockwise end position of potentiometer
Factory settings
typ. 48.0V
±0.2%, at full load, cold unit,
Line regulation
Load regulation
max. 70mV
max. 100mV
90-132 / 180-300Vac
static value, 0A Æ 5A; see Fig. 6-1
Ripple and noise voltage
max. 100mVpp
20Hz to 20MHz, 50Ohm
Output current
nom. 5A
at 48V, ambient temperature <60°C, see Fig. 6-1
nom. 6A^*)
at 48V, ambient temperature <45°C
nom. 3.75A
at 48V and 70°C ambient temperature
nom. 4.6A
at 52V, ambient temperature <60°C, see Fig. 6-1
nom. 5.5A^*)
at 52V, ambient temperature <45°C, see Fig. 6-1
nom. 3.45A
at 52V and 70°C ambient temperature
Reduce output current linearly between +45°C and +70°C
Output power
nom. 240W
continuously available
nom. 288W^*)
Power Boost^{® *)}
Overload behavior
continuous current see Fig. 6-1
Short-circuit current
min. 7A^**)
load impedance <100mOhm, see Fig. 6-1
max. 9A^**)
load impedance <100mOhm, see Fig. 6-1
Output capacitance
typ. 3 100μF
included inside the power supply
*)
**)
***)
Power Boost
This power/ current is continuously allowed up to an ambient temperature of 45°C.
Above 45°C, do not use this power/ current longer than a duty cycle of 10% and/ or not longer than 1 minute every 10 minutes.
Discharge current of output capacitors is not included.
This is the maximum output voltage which can occur at the clockwise end position of the potentiometer due to tolerances. It is not a
guaranteed value which can be achieved. The typical value is about 54.2V.
Fig. 6-1 Output voltage vs. output current,
typ.
Output Voltage
60V
52V
50
48V
40
30
20
Adjustment
Range
+60°C
+25°C
-25°C
10
Output Current
0
0 1 2 3 4 5 6 7 8 9 10A
Jul. 2015 / Rev. 2.0 DS-CS10.481-EN
All parameters are specified at 48V, 5A, 230Vac, 50Hz, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
8/26