CS10.241 Datasheet, PDF (5/26 Pages) PULS GmbH – SINGLE PHASE INPUT

C-Line
CS10.241, CS10.241-S1
24V, 10A, SINGLE PHASE INPUT
3. AC-INPUT
AC input
Mains network systems
AC input range
Allowed voltage L or N to earth
Input frequency
Turn-on voltage
Shut-down voltage
External input protection
nom. AC 100-120V / Auto-select input
200-240V ±10%
TN, TT or IT
min.
90-132Vac /
180-264Vac
85-90Vac
264-300Vac
continuous operation, lower input voltage range
continuous operation, upper input voltage range
short-tem or with reduced output current, see Fig. 3-5
max. 500ms
no harm to the power supply with input voltages between 132 and 180Vac
max. 300Vac
continuous, IEC 62103
nom. 50–60Hz
±6%
typ. 80Vac
steady-state value, see Fig. 3-1
typ. 75Vac
steady-state value, see Fig. 3-1
See recommendations in chapter 22.3.
AC 100V AC 120V AC 230V
Input current
typ.
4.34A
3.73A
2.23A at 24V, 10A, see Fig. 3-3
Power factor^*)
typ.
0.61
0.59
0.51
at 24V, 10A, see Fig. 3-4
Crest factor^**)
typ.
2.6
2.8
3.3
at 24V, 10A
Start-up delay
typ.
700ms
800ms
850ms see Fig. 3-2
Rise time
typ.
35ms
35ms
35ms
at 24V, 10A const. current load,
0mF load capacitance, see Fig. 3-2
typ.
75ms
75ms
75ms
at 24V, 10A const. current load,
10mF load capacitance,, see Fig. 3-2
Turn-on overshoot
max.
100mV
100mV
100mV see Fig. 3-2
*) The power factor is the ratio of the true (or real) power to the apparent power in an AC circuit.
**) The crest factor is the mathematical ratio of the peak value to RMS value of the input current waveform.
P_OUT
Fig. 3-1 Input voltage ranges
Rated input ranges
max.
500ms
Fig. 3-2 Turn-on behavior, definitions
Input
Voltage
Lower
range
Upper
range
(85) 90 132
V_IN
180 264 300Vac
Output
Voltage
- 5%
Start-up Rise
delay Time
Jul. 2015 / Rev. 2.0 DS-CS10.241-EN
All parameters are specified at 24V, 10A, 230Vac, 50Hz, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
5/26