PE99155 Datasheet, PDF (13/15 Pages) Peregrine Semiconductor – Radiation Hardened UltraCMOS Monolithic Point-of-Load Synchronous Buck Regulator with Integrated Switches

PE99155
Product Specification
at the switching frequency of the converter. If this
requirement is not met, the switching noise can enter the
control loop and loop stability will be lost. To ensure
sufficient attenuation at the switching frequency, a unity
gain cross over frequency one decade below the
switching frequency is recommended. Additional margin
may be desired depending on the application
requirements.
The pole created by the load and the output capacitor is
dependent on load current. The load current can vary,
likely all the way down to zero load current. When this
happens the output pole frequency falls arbitrarily low. It
is clear that this highly variable pole will not be sufficient
to set a dominant pole in the loop to ensure stability.
The recommended compensation technique is a
combined pole-zero compensation network. The zero is
set to cancel the variable load pole at minimum load so
that the load pole does not affect phase margin of the
system when the pole location is at it's minimum value,
possibly even in the bandwidth of the control loop. With
the load pole canceled by the additional zero, the added
pole in the compensation network acts as a stable
dominant pole. This dominant pole location can be
selected for both attenuation of the F_SW switching noise
and for the required phase margin and loop bandwidth.
With this compensation technique, the zero location is
calculated as 1/(2πR_CC_C). R_C and C_C should be selected
to cancel the load pole at minimum load.
If the compensation network resistor is selected to be
much less than the output impedance R_OUT of the error
operational transconductance amplifier (OTA), the
dominant pole location can then be approximated as 1/
(2πR_OUTC_C). At first glance this may seem to make the
dominant pole location dependent on the loosely
controlled error amp output impedance. However, as the
error amp output impedance drops, the DC gain of the
system and the dominant pole location reduce together.
The result is that the unity gain cross over frequency (set
by the dominant pole) is independent of OTA output
impedance variation over process and temperature.
A compensation network design spreadsheet is
available in the PE9915x Design Tool.
Figure 12. PE99155 Control Loops
Document No. 70-0307-07 │ www.psemi.com
©2011-2012 Peregrine Semiconductor Corp. All rights reserved.
Page 13 of 15