FNP1500 Datasheet, PDF (1/15 Pages) Power-One – 1500 to 5400-Watt Front-End Power Solutions

FNP1500/1800 and FXP1500/1800 Front-Ends
& FNR-3 and FXR-3 Power Shelves Data Sheet
1500 to 5400-Watt
Front-End Power Solutions
(1500 or 1800 Watts)
Front-Ends are available using either a front-mounted
AC receptacle (FNP models) or a rear-mounted AC
connector (FXP models).
I²C Management Software: All FNP/FXP front-ends can be
controlled via Power-One's GUI-driven I²C Management
software and an I²C-to-USB interface (P/N HZZ02002G). An
I²C Programming Manual describes the complete range of
parameters that can be programmed to the FNP and
FXP1500/1800 front-ends. This manual is available by
searching on "FNP1500" at www.power-one.com.
Features
• RoHS compliant for all six substances
• High density front-ends 15.2 to 18.3 W/in³
• Wide input voltage range 85 to 264 VAC
• 12 V standby voltage, 1A per front-end
• Highly efficient topology reduces operating costs
• I²C interface status and control
• I²C voltage and current limit setting
• Analog output voltage setting
• Overtemperature, output overvoltage, and output
overcurrent protection
• ORing circuits for true redundant operation:
V_o1: ORing FETs; V_o2: ORing Diodes
• Status LEDs: AC OK, DC OK, and
Fan Fail/Overtemperature Fail
Applications
• Telecommunications
• Data communications
• Servers
• Distributed power
FNR-3
Power Shelf
Description
FNR-3 and FXR-3 shelves provide up to 5400 watts in a 19" rack.
(See the Rack section for power shelf details.)
The FNP/FXP-1500/1800 are power-factor-corrected (PFC) front-ends which (depending on model type) provide a 12 VDC or 48
VDC (1500 or 1800 watt) output, and can be used in hot-swap redundant systems. Their very small dimensions allow
configuration of up to three units in a 1U rack. The FNP front-ends have a front-mounted AC receptacle and the FXP front-ends
have a rear-mounted AC connector. The highly-efficient thermal design with internal-fan cooling permits their use over wide
temperature ranges and provides very-high reliability.
Status information is provided with front panel LEDs, logic signals, and via an I²C management interface. In addition, the I²C bus
can enable the power supply, set high fan speed, adjust the output voltage, and set the output current limit. The FNP and
FXP-1500/1800's meet international safety standards and display the CE-Mark for the European Low Voltage Directive (LVD).
Power-shelf solutions provide rectification, system management, and power distribution, while maintaining high reliability and
offering flexibility for future expansion. The power shelves can be configured with up to three hot-swappable 1500 or 1800-watt
AC-DC front-ends.
DEC 12, 2006 revised to FEB 22, 2007
Page 1 of 15
www.power-one.com