6086 Datasheet, PDF (3/3 Pages) Pomona Electronics – ESD Wrist Strap Tester

Model 6086
ESD Wrist Strap Tester
CALIBRATION:
Calibration of Pomona model 6086 is recommended annually. Calibration should be performed to ensure that
the tester is operating within limits. The calibration may be checked with discrete resistors.
Resistance Value (+/- 10%)
675 KOhms
825 KOhms
8.5 MOhms
11.5 MOhms
Test Display
Red (Low-hazard)
Green (OK-in limits)
Green (OK-in limits)
Red (High resistance)
To calibrate, simple place each resistance value (see table) between the touch plate and banana jack grounds.
Observe that the proper test display LED is on (see table) for the selected resistor. Be sure to hold the test cord
at an insulated point, so the resistance value in not affected by the body. There are no adjustments inside.
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies.
Sales: 800-490-2361 Fax: [phone] Technical Support: 800-241-2060 ([e-mail])
For “Where to Buy” information, visit the Pomona web site at www.pomonaelectronics.com
Rev: 100
D1094536
Page 3 of 3