PL611S-18 Datasheet, PDF (6/9 Pages) PhaseLink Corporation – 0.5kHz-125MHz MHz to KHz Programmable ClockTM

P (Preliminary) L611s-18
0.5kHz-125MHz MHz to KHz Programmable Clock^TM
PCB LAYOUT CONSIDERATIONS FOR PERFORMANCE OPTIMIZATION
DFN-6L Evaluation Board
The following guidelines are to assist you with a performance optimized PCB design:
Signal Integrity and Termination
Considerations
Decoupling and Power Supply
Considerations
- Keep traces short!
- Trace = Inductor. With a capacitive load this equals
ringing!
- Long trace = Transmission Line. Without proper
termination this will cause reflections ( looks like ringing ).
- Design long traces as “striplines” or “microstrips” with
defined impedance.
- Match trace at one side to avoid reflections bouncing
back and forth.
- Place decoupling capacitors as close as possible to the
VDD pin(s) to limit noise from the power supply
- Multiple VDD pins should be decoupled separately for
best performance.
- Addition of a ferrite bead in series with VDD can help
prevent noise from other board sources
- Value of decoupling capacitor is frequency dependant.
Typical values to use are 0.1µF for designs using crystals
< 50MHz and 0.01µF for designs using crystals > 50MHz.
Typical CMOS termination
Place Series Resistor as close as possible to CMOS output
CMOS Output Buffer
( Typical buffer impedance 20 Ω )
50Ω line
To CMOS Input
Series Resistor
Use value to match output
buffer impedance to 50 Ω
trace. Typical value 30 Ω
47745 Fremont Blvd., Fremont, California 94538 Tel [phone] Fax [phone] www.phaselink.com Rev 2/23/07 Page 6