PL611S-26 Datasheet, PDF (4/8 Pages) PhaseLink Corporation – 1.8V-3.3V PicoPLLTM Programmable Clock

P (Preliminary) L611s-26
1.8V-3.3V PicoPLL^TM Programmable Clock
ELECTRICAL SPECIFICATIONS
ABSOLUTE MAXIMUM RATINGS
PARAMETERS
SYMBOL
MIN.
MAX.
UNITS
Supply Voltage Range
Input Voltage Range
Output Voltage Range
Soldering Temperature (Green package)
VDD
-0.5
7
V
VI
-0.5
VDD+0.5
V
VO
-0.5
VDD+0.5
V
260
°C
Data Retention @ 85°C
10
Year
Storage Temperature
Ambient Operating Temperature*
TS
-65
150
°C
-40
85
°C
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the device
and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other conditions above
the operational limits noted in this specification is not implied. *Operating temperature is guaranteed by design. Parts are tested to commercial grade only.
AC SPECIFICATIONS
PARAMETERS
CONDITIONS
@ VDD =3.3V
Input (FIN) Frequency
@ VDD =2.5V
@ VDD =1.8V
Input (FIN) Signal Amplitude
Internally AC coupled (High Frequency)
Input (FIN) Signal Amplitude
Internally AC coupled (Low Frequency)
3.3V <50MHz, 2.5V <40MHz, 1.8V <15MHz
@ VDD =3.3V
Output Frequency
@ VDD =2.5V
@ VDD =1.8V
Settling Time
At power-up (after VDD increases over 1.62V)
Output Enable Time
OE Function; Ta=25º C, 15pF Load
PDB Function; Ta=25º C, 15pF Load
Output Rise Time
15pF Load, 10/90% VDD, High Drive, 3.3V
Output Fall Time
15pF Load, 90/10% VDD, High Drive, 3.3V
Duty Cycle
VDD /2
Period Jitter,Pk-to-Pk*
With capacitive decoupling between VDD and
(measured from 10,000 samples) GND.
* Note: Jitter performance depends on the programming parameters.
MIN. TYP. MAX. UNITS
200
1
166 MHz
133
0.9
VDD
Vpp
0.1
VDD
Vpp
200 MHz
166 MHz
133 MHz
2
ms
10
ns
2
ms
1.2
1.7
ns
1.2
1.7
ns
45
50
55
%
70
ps
47745 Fremont Blvd., Fremont, California 94538 Tel [phone] Fax [phone] www.phaselink.com Rev 12/12/06 Page 4